First Bedini Monopole Energizer
Uploader Comments (timh39)
All Comments (14)
-
The negative on the primary battery go’s to the inner 20 gauge wire on the coil which also go’s to the emitter on the transistor and the inner 24 gauge wire from the coil go’s to the collator on the transistor then the neon bulb is connected to the emitter and collator does it matter which way I put the neon bulb? And is there any problems you see in this hookup? I noticed when I put a drill bit in the coil it shoots it out and my core is made of drill bits. help!
-
The potentiometer is connected to a 24 gauge outside coil wire. My 1N4007 diode is connected to the positive on the secondary battery. Then the outside 20 gauge wire runs to negative on the secondary battery and on the positive on the primary battery.
-
Nice video! Hi I have been trying to get the bedini motor to work, but the wheel just comes to a stop. My setup is 1N4001 diode is connected on the emitter to the base on the transistor. Then the base is connected to a 470 resister. Then resister is connected to the potentiometer.
-
-
nice one...
-
Great work!!
Keep it up!!!!
how did u make the control box
legogun13 3 years ago
The control box was purchased at radio shack, also the switches,lights,circuit board and terminal strip. I just decided where to best mount everything and started putting it together. It helps keep everything organized and makes coil hook-up and battery hook-up very fast. Best of luck if you are building one, the results are very interesting.
timh39 3 years ago
best review
legogun13 3 years ago
Thank you for the very nice comment.
timh39 3 years ago
Nice job & excelint presintation.
5 stars
RHEAD100 3 years ago
Thank you for the very nice comments. Sorry to take so long to reply, been away from the computer for awhile.
timh39 3 years ago