My Homemade Guitar #2 Work in Progress #5
Loading...
Loading...
3,637
Loading...
1:18
My Homemade Guitar #2 Work in Progress #6by jckray1,741 views- 0:42
My Homemade Guitar #2 work in progress #4by jckray4,866 views
- 0:33
My Homemade Guitar #2 Work In Progress #3by jckray1,020 views
- 0:54
Routing a Mojo Guitar Bodyby MojoBodies2,132 views
- 0:59
Homemade Guitar #2 (Completed)by jckray2,756 views
- 3:26
My Guitar and How I Built Itby Demahlguitar43,178 views
- 9:22
Blues Creek Guitars Inlay Techniques - Part 1by glasalle15,627 views
- 1:03
My homemade guitar #2 work in progress #1by jckray679 views
- 1:31
Routing Pickup Cavity Legsby GuitarBrew5,550 views
- 1:05
Routing the Electronics Cavityby GuitarBrew3,450 views
- 3:07
Sully's Guitar Garage - Building a Firebird - part 4by jsullysix5,179 views
- 3:44
rear routing a tele guitar body luthier 2 of 2 project pin routerby thebigdguitars7,420 views
- 3:01
My Second Homemade Guitar Demoby jckray1,077 views
- 69 videosmine
- 1:02
Attaching a Shaper Router Table to a Dremel Rotary Toolby Dremel41064,287 views
- 1:54
Routing Body to Sizeby ThroughTrueWoodwork2,807 views
- 0:57
Steve Vai's home made Jem guitar No1 - before painting.wmvby MrNktop6,709 views
- 1:37
DIY - Electric Guitarby 68dalo7,059 views
- 1:49
Nickel spray paint for EMI shielding of plastic housingsby fatalerror80003,664 views
- 1:05
Routing the Binding Channelby GuitarBrew6,656 views
- 9:21
Shark Inlay Viking Guitar Headstock Inlayby SharkInlay9,835 views
Well done! Can you upload any new progress?
robbiemclark 2 weeks ago
@robbiemclark @robbiemclark I actually finished this guitar about 2 years ago. if u look under my videos u'll fin a work in progress #6 as well as a vid of it completed and a demo of it.
jckray 2 weeks ago
Did you apply the veer before or after you cut the body shape. If so, how did you trip it?
jim10376 2 years ago
I glued the vineer after. i trimed it using a plunge router using a router bit with a baring on the bottom.
jckray 2 years ago
Did you have any problems with "tear-away" of the veneer by using the plunge router?
jim10376 2 years ago
no i didnt u just have to be very careful u are always going in the direction. My veneer was 1/4 in thick it might not work as well on thiner ones as well.
jckray 2 years ago