5 Axis Break-Out Board with Relay V5

This is a video series on the fundamentals of the CNC Electronics. In the video, I go over all of the basic information and uses of the 5 Axis Breakout Board with Relay.

Category:

Science & Technology

Tags:

• axis
• breakout
• board
• realy

[thechoochman28]

Did you ever get around to making a Mach 3 setup video for this BOB?

[anajonesr]

@thechoochman28 i need to. I will do this.

[thechoochman28]

Will you be making a mach 3 setup video for this as well or full wiring video?

[anajonesr]

@thechoochman28 Good idea. I will make one soon.

[shortyjk95]

@anajonesr well they are very clear and well explained its just im not that inclined with electrical stuff so i got lost

[anajonesr]

@thechoochman28 I agree. I really should tell my China supplier to change this.

[thechoochman28]

@anajonesr Thank you. I get confused if the standard 3 axis board setup is the same as this and I haven't had the time to really sit down and troubleshoot. I noticed a lack of information out there on the setup.

[thechoochman28]

@anajonesr I think it's clear, the only thing that could be confusing is sometimes drivers have different labeling i.e. DIR+ DIR- PUL+ PUL- etc.

[anajonesr]

@shortyjk95 Really? I thought it was pretty clear. I will see about making my videos clearer in the future.