HHO u-tube build
Loading...
Link to this comment:
Uploader Comments (Jcarr62)
All Comments (18)
-
sorry for the double post but wondering would it also affect reading using different size tubing ? I do have some oxygen line less than 1/4" . the tube I am about to test from is 1/2" inside
I was planning to tape up the smaller utube so it acted like a cork.
-
My question is, Would the reading be affected if a person used like vegetable oil or any light oil. I remembered your Vid you had before--- Now I need one to check crank case pressure out of a small engine I came back and decided to build one My object being that an oil may give a steadier reading., because of the viscosity?
-
My question is, Would the reading be affected if a person used like vegetable oil or any light oil. I remembered you Vid you had before now to check crank case pressure out of a small engine I came back and decided to build one My object being that an oil may give a steadier reading., because of the viscosity?
-
actually, a brand name water Manometer can be expensive. over 100 bucks.
-
how to create vacuum for this apparatus??????????
that black tube is connected to ?????????/
-
how to create vacuum for this apparatus??????????
-
uhm hello..if you don't mind me asking.. what is the measure of the vinyl hose?
-
OK! THANKZ
-
I watched your video with great interest. Im trying to diagnose a problem with a RV refrigerator and needed to make one of these manometers. After using my homemade U tube meter I was quite confused as to why the readings I got were so low. It would have been helpful if you stated the one inch readings need to be doubled or marked off in half increments and numbered every half inch.
5:24First Test Of The U-tubeby Jcarr622,122 views
- 5:26Test # 2 with the u-tubeby Jcarr62605 views
- 3:35using 8 dollar manometer to balance BMW boxer e...by phoebelala30,637 views
- 5:15HHO install Ram 1500 # 9, O2 sensor extendersby RadGenH2O9,811 views
- 2:13hho generatorby dotman5006,298 views
- 9:56HHO piggy back bubblerby Jcarr621,014 views
- 9:18HHO The Stinger Part 1by Jcarr621,905 views
- 4:51Introduction to Manometers: Two Essential Rulesby DrMorrisonMTU38,794 views
- 1:52Universal indicator U-tubeby ChemToddler16,323 views
- 2:47Manometer, Throttle, Bodies, Carbs, Balancer, b...by phoebelala30,720 views
- 5:26manometer tiub - u mudahby ehin649958 views
- 1:07HHO PLEXIGLASS CELLby cavebandit16,997 views
- 2:10HHO Lots and Lots of HHOby energyfromwater144,803 views
- 0:36Carb sync using homebrew manometer.by jasonascott12,849 views
- 0:26Home made Motorcycle Manometer for tuning 4 Cyl...by jimmyfandino13,517 views
- 7:19#6 Playing and Working with HHO FUEL GAS !!!!!!by energiaregia6,670 views
- 4:00Mythbusters may have not busted this one.by mikeyidh596,795 views
- 0:40My Hydrogen Generator (1st test)by skibearfish41,197 views
- 1:26Custom Fuel Level Manometer www.gentune.comby petehdgs810 views
What is the black thing connected with the vinyl tube?
lopus16 3 years ago
It is a clamp that is holding the hose till the glue dries that's all
Jcarr62 3 years ago
hey what was that red material you used as an indicator? Thanks a lot
riujithetechnician 3 years ago
All I did is add food-coloring to the water to make it show up better. The red thing that you see on the video is just a clamp that I have holding the vinyl tube until the glue drys.
Bonze
Jcarr62 3 years ago
You got it any questions feel free to ask I will do my best to help
Bonze
Jcarr62 3 years ago