AR Fab Subaru Break-in Part 2
Uploader Comments (frknlow1)
All Comments (12)
-
y is the motor sitting so far forward???? good luck putting front bar on... or have good weight distribution lol
-
fuck you this is insane....
-
@Cha27se "This engine is actually a 2.0L block that is sleeved with our 100mm pistons, a stock 2.5L crank, stock ported heads with +.5mm valves, a very nasty set of cams and a set of EAGLE(ARP 2000 rod bolts...the standard bolts) rods FTW!!!"
It's sleeved 2.0 block halves.
-
@Cha27se Epic Motorsports disagrees with you....they tuned the car. :)
"I was just up at AR fab yesterday tuning a car and Howard and Tommy had the shop drag car on the dyno.
730whpat 33 psi
it spun the tires at 40psi but made 730lbs of tq hp should have been over 800 he's going to try to bring the car down here to fatalville next weekend to run it on our dyno then hit the strip!
Car is insane. Oh BTW its a 2.0l wrx motor Woot!"
-
@anthonyberry4 Not a 2 liter retard, watch his other videos. Clearly a 2.7l
-
Put some clothes on it. How well do the transmissions hold up to that kind of torque? Badass bugeye!
-
How the fcuk they gonna get a bonnet on that thing..?? ;-)
Geez what a monster, well done..
-
2.0 liter FTMFW !!!
-
that's amazing. nice work!
Thanks Shawn. Hopefully I can get some of the safety mods done today so I can go to the track soon! Its busy busy busy around here I can hardly get a chance to work on it! :(
frknlow1 2 years ago