Epoxy Bubble Buster by Mud Hole

Tired of getting bubbles in your epoxy? Then CRB Bubble Buster™ is for you!

Specially formulated for rod builders to release and help remove the bubbles that occur when applying 2-part epoxy finish to your rods. CRB Bubble Buster™ works by releasing the surface tension of the 2-part epoxy, allowing the encapsulated bubbles to rise and burst. The CRB Bubble Buster™ leaves no residue after application and works with all brands of 2-part rod finish epoxy.

CRB Bubble Buster™ is perfect for when the use of an open flame (i.e. flaming of the finish) is not an option great for schools, apartments, offices and other areas where an open flame is dangerous or not desirable.

Easy Application apply any 2 part epoxy rod finish to your custom rod and allow to level, position the CRB Bubble Buster™ easy spray bottle approximately 6 to 8 away from the epoxy surface and pump one spray to each side of the finished area.

CRB Bubble Buster ™ is offered in a 2oz easy spray bottle and is exclusively available at www.MUDHOLE.com

Category:

Sports

Tags:

• Rod Epoxy
• Fishing Rod Building
• Bubble Buster
• Mud Hole
• Custom Rods
• Rod Finish
• Flex Coat

[v1806v]

@203066111 you are right. I think as))

[terrthom]

what about opaque resin?

[203066111]

Great Video Showing Acetone, Lacquer Thinner or Denatured Alcohol Being Sprayed On The Bubbles Will Help Reduce The Viscosity Of The Resin Allowing The Bubbles To Rise Easier. Also Makes The Resin Weaker Once Cured If To Much Is Sprayed.

[laurelridgerods]

Dude this mudhole music is jammin like schmuckkers jelly

[fusionstar916]

Looks like it increases the viscosity of the epoxy a little bit which allows the air bubbles to float to the surface. I dont know i'm not a scientist.

[niftybob20]

but does it effect dry time or the strength of the epoxy? any coloration problems long term?