wiboater4's channel
Loading...
149
subscribers
122,774
video views
Uploaded videos
1-10 of 84-
20111129114638.m2ts
wiboater4
74 views
Some video of the Lenz 2 on the dock since I re did the wing shape and put a new 55 turn per coil stator on the 12 inch alt. It has improved performance on it but still a ...
-
DIY solar panels on home made tracker.
wiboater4
157 views
Just a quick video showing the panels elevated for winter sun angle. Shows sissors for raising and lowering elevation. Still have stuff to do on it yet but I am able to ru...
-
4 completed DIY solar panels 60 cell each
wiboater4
542 views
Showing all four completed panels. Shows how much better the one I made with the foam oven turned out than the ones I used heat lamps on. There is better control with the o...
-
Solar panel in plastic vacuum bag after heating
wiboater4
753 views
This time it looks better , it's hard to tell thru the plastic sheeting. It wasn't perfect but was the best one I've made so far. I didn't show it but even the tedlar on th...
-
solar panel after reheating with more heat
wiboater4
290 views
Explaining some of the things that could be done better on the next one.
-
showing panel with EVA not quite melted enough
wiboater4
492 views
Thought I had heated it long enough but near the end when I tipped it up you can see the lighter color on each side of the tabbing wire where the EVA isn't melted completel...
-
Oven heating up to over 200 degrees F.
wiboater4
159 views
Oven at higher temperature. I said I turned the heat gun down but later left it on the high setting. You need to get up to about 212 to 240 degrees Farenheight to melt the ...
-
DIY solar panel laminator oven
wiboater4
537 views
Showing Temp of Laminator oven. The heat gun is a 500 degree model. I found out later that the needle sticks on the temp prob. I got it hot enough later so the needle was ...
-
Solar panel diy oven for laminating EVA and Tedlar
wiboater4
1,103 views
Foam board oven . I have the sides just taped up with masking tape so I could remove it for storage. It worked fine but you have to watch it and re seal it if it starts to ...
-
Solar panel laminator construction/setup
wiboater4
997 views
This shows the vacuum bag sealed and the vacuum pump removing the air pulling the cells and the EVA down tight to the glass before heating. I used a plastic tubing but next...
Advertisement
About wiboater4's channel
more
less
Play all(84)