-
3 months ago
Towing And Recovery In The Ditch - Driver Fell Asleep
The aftermath of a sleepy driver.
add me on Facebook http://www.facebook.com/gor...
Twitter http://www.twitter.com/gord...
...
GordyMariFilms • 7,497 views
utoobdude67
liked
-
-
-
-
-
-
-
10 months ago
Vista Cruiser Small Burnout Aug 27 09 003
With the Auburn limited slip differential and 3.73 final drive gears, it was time to see if this car could spin the tires a little bit. Space was ...
spikedpunk • 1,303 views
utoobdude67
liked
-
10 months ago
Grizzly Locker Operation
A look into the operation and inner workings of a Yukon Grizzly Locker.
YukonGear • 28,047 views
utoobdude67
commented:
-
10 months ago
Removing Rust from Automobile Header(Electrolysis)
Using a battery charger, washing soda, and a tub full of water, we have reduced the iron oxide back into elemental iron. This came at the expense o...
JohnQuickUSF • 36,363 views
utoobdude67
commented:
I've done this process several times and it works fantastic. As said below, don't use Stainless Steel, and of course do not use alluminum. Stainless Steel does make some form of Haz Mat and I don't know what its called, but doesn't matter what its called, don't use SS it can be harmful. I have us...
-
10 months ago
How to remove rust with electricity
Just a little instructional video
Removing rust with a battery charger
What you need:
Plastic bucket
Battery charger
Washing soda (or baking soda)...
bah53 • 40,588 views
utoobdude67
commented:
@skootb2 I was using a 2/10/50 amp charger. On 50 amp, it kept tripping the internal breaker on the charger itself, so I had to run it at 10amp and it ran as long as I wanted it to.
-
11 months ago
1986 K10 Silverado Suburban, With TPI Fuel Injection
Many people have asked for a video of my TPI 350 Powered 86 Suburban.
Specs:86(only)GM Goodwrench replacement engine. 193(87-95) truck heads, Comp...
jameslleary • 1,891 views
utoobdude67
commented:
Damn, Good Job. That's bad ass !!! Even more so that is CA approved and legal.
-
11 months ago
Greyson Chance Performs "Waiting Outside The Lines" on Ellen
Buy Greyson's debut album "Hold On 'Til The Night" at http://itunes.com/greysonch.... Greyson Chance Performs "Waiting Outside The Lines" on Elle...
greyson97 • 1,063,218 views
utoobdude67
liked
-
11 months ago
CHEVY 4X4 K20 BIG RED
1983 Chevy K20 350 4 Bolt Main SM465 Manual Transmission With Granny Gear NP208 Transfer Case Edelbrock 750cfm Carb Edelbrock Air Gap Intake Chevy...
offroadjoe83 • 88,565 views
utoobdude67
commented:
That's beautiful !!! I'd like to see this guy sign up at gmsquarebody and share his build. They are getting a good group of offroaders on that forum with these SAS trucks.
-
-
-
-
1 year ago
-
1 year ago
The death of Steve Irwin
This is a reenactment of the death of crocodile hunter Steve Irwin. May he rest in peace.
meleos • 1,710,339 views
utoobdude67
commented:
Not Even Cool, Only a lowlife prick would do this type of crap, for such a great human being. Things like this are only cool, when it happens to idiots like yourself.
-
1 year ago
-
1 year ago
My POS Truck
'75 Chevy Scottsdale 20. Small Block 350
Fighterofwars • 10,502 views
utoobdude67
commented:
I'm afraid I couldn't own that one. ..... It doesn't have AC.
-
1 year ago
Duramax Diesel Grand National CLONE
This is actually an Oldsmobile chasis that was converted into a Grand National looking Buick. This car is powered by a 6.6 litre Duramax Diesel eng...
MarvinSanti • 145,792 views
utoobdude67
commented:
Absolutley Brilliant idea. You hear of people converting old trucks and Burbs to Cummings, or Duramax, but first time I ever I seen someone consider it to a car. That's bad ass !!!
But I see we have some lame haters. Probably the idiots running giggly juice to a ricer and blowing burnt oil out...
-
1 year ago
Pt 7 Final International IHC 300 Utility
Final segement in the 300 Utility camshaft replacement series, along with the review of the Magix Movie Edit Pro MX 18.
Love the mixer and all of ...
ElderlyIron • 1,141 views
-
1 year ago
Walk Around my Christine and Listen to George Thorogood
Interested in Christine?
58Donnie • 111,214 views
utoobdude67
commented:
Wow, Nice Car. I'm not a Dodge fan and like that car.
-
1 year ago
Chrome cars
must watch video.........................
....excuse the music 04cscholes • 290,559 views
utoobdude67
commented:
Looks like hell.
-
1 year ago
SUSAN BOYLE ☆ KILLING ME SOFTLY ☆
SUSAN BOYLE - Killing Me Softly (High Quality Version)
TheUberDeeJay • 4,334,417 views
utoobdude67
commented:
@MrMiraculous13 Agree. Awesome singer, Fabulous voice, and truely inspirational, but I'll agree, this is the first ever SB song that I can honestly say, its not a song for her to be singing. Very generic and not up to her ability at all. I even wonder if its really her. Or maybe is it that she d...
-
1 year ago
'85 Chevy K20 383 Burnout
Burnout with '85 chevy k20 with a 383 stroker.
ALEXort2007 • 72,615 views
utoobdude67
commented:
@Baseballstud5964 Always got be a dickweed in the crowd. And what are you doing comparing a 2WD to a 4WD? Many prefer short 4WD too, but I don't. Much better angle for the driveline with a lift. Of ourse 2 wheel lover wouldn't understand that. And for your 100ft burnout, you're about an idiot. My...
-
1 year ago
63 impala video 56 grinding grunt work
After driving it and enjoying it for a few hundred more miles, its time to finish that dreaded trunk. This really is a time consuming job and its t...
restodan • 12,862 views
utoobdude67
commented:
IF that's an original truck 350, its likley a 4bolt main if that matters.
I agree, anytime you can keep an old classic out of the junk yard, you do it. It makes me cringe at times when I go to wrecking yards and see what people have allowed to go in there for $100 or so. Keep'em alive guys, and ...
-
1 year ago
63 impala video 55 driving it again
I have been driving it and not working on it for about a month now. I knew that would happen once I got it driving again, but it keeps my interest ...
restodan • 16,460 views
utoobdude67
commented:
I think I'd disagree with, Reproduction metal would have been better, I think anytime you can transplant OEM stuff, rather than aftermarket, that's what should be done. In some cases you don't have a choice, but was with this, you were able to find facotry OEM metal out of a donor vehicle, and t...
-
1 year ago
63 impala video 75 TEST DRIVE, and 72 olds 88 conv for sale
hear the $40 duals, and a drive down the road. See an old automobile assembly line a retro Sinclair gas station, and a nice 72 olds 88 conv for sal...
restodan • 1,659 views
-
1 year ago
63 impala video 33
These are good times, I'm very proud of her. The 63 has exhaust and I have cleaned it up some, several drives to the car wash, lots of vacuuming, I...
restodan • 13,452 views
utoobdude67
commented:
Cute Daughter, and that's great, she take the initiative to be proud of you. Even my 13yo son just takes my projects for granted. Most adults find it amazing the things I can dig out of a pasture and have running. I drug an old pick home 1 day for $100, and got laughed at. I laughed even harder, ...
-
1 year ago
63 impala video 31
great buys from the wrecking yard
restodan • 10,021 views
utoobdude67
commented:
My kinda guy. I do the exact same thing. Brake parts is just one thing I don't do used, BUT, I have done it several times because its very very easy to tell when they are like brand new and no sense in letting them go to the crusher.
-
1 year ago
63 impala video 28
After starting the $50 motor and it seems okay, I pulled it back out to replace the leaky oil pan gasket and the other gaskets and I cleaned the ...
restodan • 11,878 views
utoobdude67
commented:
I am also taught by the old timers, may they now RIP. I carry on their tricks to the younger guys now that I'm 44. I noticed in a couple videos back, I said to myself, why is this guy installing this unkown motor wo firing it up first. Should set it in a tire, used a gas can and battery, with a h...
-
1 year ago
63 impala video 19
what do you know, the 327 has a steel crank in it, how to tell the difference between a cast iron crankshaft and a forged steel crankshaft.
restodan • 10,717 views
utoobdude67
commented:
Steel Crank Whudda you know??? I know that is normal. ALL SMALL JOURNAL 327's come factory with Steel Forged Cranks, as well as ALL 283's do too. Since 283 was only a small journal motor, ALL 283 are Forged crank. 327's from 1962-1967 are small journal and ALL of them will be forged. In 68 and 69...
-
1 year ago
Pharmacist Charged With Murder Returns to Work
An Oklahoma City pharmacist charged with murder after a robbery attempt at his store went back to work Tuesday with a private security guard to pro...
AssociatedPress • 11,360 views
utoobdude67
commented:
In case it matters, I happen to be caucasion male in OKC,OK and I also have conceal to carry permit, and I'd have done the same thing. And it doesn't matter if it were a white kid, Indian kid, hispanic kid, I'd have done it the same way. Why does the race card always come out? Ridiculous! And all...
-
1 year ago
Sexy Tattoos on Women! Some sexy tattoo designs.
CLICK HERE http://www.tatdb.com
Sexy Tattoos for Women, Beautiful Sexy tattooed girls, sexy Women with tattoos. Some sexy feminine tattoo designs.
jacobtat • 409,539 views
utoobdude67
commented:
A great way to trash beautiful women. Sad !!! Great Art BTW, But, Art belongs on a wall or in a museum, not a person.
@MentalChainsawDude Unless you have good traction to both wheels off road, its likely to stay locked even in a turn off road, just that the inside of the turn wheel is likely to be digging dirt while making the turn. If your traction is that good to both wheels off road, then you wouldn't need it...