On the Go With Moose

Carving a door on the Haas SR-100 Sheet Router at The Geek Group's Leonard Street Labs in Grand Rapids, Michigan. This is the door that goes into t...

Using the Haas SR-100 at The Geek Group's Leonard Street Labs to engrave (V-Carve) into wood. I used a Her-Saf V-Cutter and Vectric V-Carve Pro to ...

Turning down some rosewood for a large pen. It took some work to come up with an efficient way to mount large barrels on the same mandrel without r...

Turning a pen at The Geek Group's Leonard Street Labs in Grand Rapids, Michigan, on the super awesome Haas TL-1 lathe.

I put a potato into the Haas TL1 at The Geek Group's Leonard Street Labs. I couldn't think of a valid reason to NOT put a potato in the lathe so I ...

Another piece of cherry- smaller this time. ;) I'm just doing a programming test on it (which, incidentally, didn't quite work and I had to change ...

Running a profile cut on a rather large piece of cherry on the Haas TL-1 at The Geek Group's HQ.

Turning a piece of mulberry on the Haas TL-1 Lathe at The Geek Group's headquarters in Grand Rapids Michigan. This piece is fairly large (11.5" lon...

Wood

Uhmw

Wood

Finish cutting on the aluminum vase, using Iscar tooling on the Haas TM-1 Milling Machine at the Geek Group HQ.

I made one of these out of oak a few weeks ago and decided to make one out of aluminum. (Because it was the right size, I just rummaged around the ...

Using the Haas TM-1 Milling machine at The Geek Group HQ to surface finish some mild steel. The original metal was rusty and not very square.

Using the Haas TM-1 at The Geek Group to machine down a piece of bronze.

Using the Haas TM-1 Mill to make some pretty epic dominoes using the old rock maple from the gym floor at The Geek Group.

A test video! Warming up the CNC equipment at Geek HQ.

Made at http://pummelvision.com