Uploaded videos
1-10 of 19-
ESM Fw-190D flight #19
ticketec
229 views
ESM Fw-190D flight number 19, SAMMBR airfield, powered by an XYZ 53cc STS twin spinning a 22x10 prop, HS-5625MG servos throughout, Smartfly Super reg, and AR9000 R/X. Sierr...
-
Dragon Anamatronics pilot for the ESM Fw-190d
ticketec
594 views
Dragon pilot modified with churchill creations bits and custom made body. Pololu maestro control board. Powered by the R/X and running totally independantly.
All this will...
-
Dragon 1/6 Luftwaffe pilot using churchill creations
ticketec
374 views
Chruchill creations pan and tilt items, custom vac-formed chest, and foam lower torso. using a pololu board to run the loop, this is just the first run of the setup. new pr...
-
ESM 82" Fw-190D First flight
ticketec
1,631 views
First flight of the new ESM 82" Fw-190 Dora. Powered by an XYZ 53cc STS twin, sierra mains and wheels.
-
Dynam 1.2m PBY Catalina at redcliffe
ticketec
2,053 views
Here is a quick video of my 1.2m Dynam PBY catalina flown off the water at woody point (redcliffe) brisbane. Stock setup and using a 3s 2100mah Li-po and orange R/X from ho...
-
XYZ 53cc STS Twin first run
ticketec
1,647 views
Here is a quick video of the first run of the XYZ 53cc STS Twin mounted to the new ESM 83" Fw-190 Dora. I was going to video the starting up of the engine but it started on...
-
Byron F-16 R/C model
ticketec
983 views
This is the first flight with the retracts installed in the EDF converted byron F-16. The flight was conducted at SAAMBA ( formerly PRAMS) Brisbane, Australia
Scorpion 6...
-
Byron F-16 R/c model retracts
ticketec
1,463 views
I have just finished installing the retracts into my byron 1/8 F-16.
These are the spring air 102HD, with Hobbycity 5mm oleo's, wheels, and VQ models nose strut. The ret...
-
ESM 82" Hawker Hurricane R/C model
ticketec
7,661 views
This is the maiden flight of a ESM 82" hawker hurricane R/C model powered by an evolution 40GX engine and an AR9100 R/X.
The maiden was done at SAAMBR (PRAMS) in brisban...
-
B737NG simulator video
ticketec
2,684 views
This is a short video of a home built Boeing 737-800 simulator under construction.
Using Fs2004, PMDG model, components from Opencockpits, and 5 PC's to make it all work.
Advertisement










Play all(19)