smetters20's channel
Loading...
-
-
-
-
-
2 weeks ago
Water Powered Car Inventor was Killed!
This is an old clip shown about 20 years ago of a local inventor holding many patents on his dune buggy style car. His na...
smetters20
favorited
-
2 weeks ago
Inventor Jailed
Paul was approached by members of the oil cartel that made him offers for his patent, each time he demanded a contractual provision that the inven...
smetters20
favorited
-
3 months ago
Dodge Ram Flowmaster 40 series
My once was 1996 Dodge ram 5.2L with 3" flowmaster Original 40 series out the side
smetters20
commented:
-
4 months ago
fish in there temp kiddy pool until funds allow 4 big tank
6'x6'x24" kiddie pool with my 15 fish gang
smetters20
commented:
@corrie110 . Also last I looked salmon and trout were cold water fish...........next
-
5 months ago
-
-
5 months ago
Mazda 3 Cold air Intake Boomz
Mazda 3 Cold air Intake Boomz
smetters20
commented:
@carrionpvp
cold air good low down tq. short ram better throttle response, loss some low down tq, but shines in the high rpms.
-
6 months ago
1970 dodge challenger
April 5th 2008. 440 bored 60 over, long tube headers with purple hornies dumped. Tci 3 speed racing trans, 3k stall. Edelbrock aluminum heads, weia...
smetters20
commented:
@JoshW23
i dont know where u idiots are comming up with a fucking redneck. None of us drive a 1980 pickup with no mufflers, listen to cuntry, take baths in mud or fuck our sisters. Go move to kentucky if you want a redneck fuck.
-
7 months ago
Cant have enough air
New 28" bubble wand with power head. 55gallon, cascade 1000 canister filter, 3 common, 1 comet, 3 red tail tin foils, 1 minnow, 1 common pleco, 1 c...
smetters20
commented:
@greatwhitemadness
Was just for looks. One day I would love to have all walls shooting bubbles, with led's behind them. But for a big tank I have that would take alot.
-
11 months ago
Mazda 3 2.3l tip change
I hate the dam stock tip so I cut it off and put this chepo on until I finalize my exhaust set up
smetters20
commented:
@carrionpvp
I cut the other side out using a template jig saw and 150 grit sand paper
About smetters20's channel
@Antrocker08 center in/ center out