Tikka308 a.k.a. NYC CNC
Loading...
1,467
subscribers
1,314,565
video views
Uploaded videos
1-10 of 132-
Polar Air Compressor - Overview and Noise Demonstration
saunixcomp
469 views
Showing fellow machinists, fabricators, shop guys and DIYers more information on the our new Polar Air by Eaton Compressor 2 Stage, 5HP 80 Gallon Air Compressor. Part num...
-
Tormach Tooling System: Maximizing Performance and Preventing Collet Slip
saunixcomp
612 views
A video overview on how to maintain, improve and maximize the Tormach TTS tooling system in order to prevent collet slip. Includes information on cleaning & degreasing as ...
-
Torchmate CNC Plasma 4x4 Arrived! Unpacking and Assembly
saunixcomp
1,252 views
The Torchmate CNC plasma is here! This video covers the freight delivery, unpacking and initial setup of the machine, water table and frame
-
Powder Coating Aluminum in the Home Shop - How to Basics, Tips, Tricks & More
saunixcomp
1,686 views
Using an Eastwood HotCoat Powder Coating Gun to demonstrate how to properly clean and powder coat paint a machined aluminum part. In addition to powder coating a sample pa...
-
Tormach PCNC 1100 CNC Mill - Series III Upgrade! Ch. 25
saunixcomp
697 views
Installing the Series III upgrade on my Tormach PCNC 1100 - replacing/upgrading all three axis motors and motor drivers. Video includes a detailed explanation of how to in...
-
Torchmate Chapter 2 - Air Compressor & Air Dryer have arrived!
saunixcomp
944 views
The Polar (By Eaton Compressor) 5 HP, 2-Stage, Single 80-Gallon Vertical Air Compressor and Harbor Freight air dryer have arrived! The Torchmate 4x4 ships from the factory...
-
New Torchmate CNC Plasma Cutter! Ordered 4x4 Growth Series Machine!
saunixcomp
1,680 views
New Equipment on the way folks! We've been looking forward to getting a plasma for a while now. Should be a great machine: Torchmate Growth Series 4x4 with AVHC, water be...
-
Tormach PCNC 1100 CNC Mill - Adjusting Gibs - Ch. 25
saunixcomp
2,032 views
Adjusting Gibs on my PCNC 1100 CNC Mill using a dial indicator
-
Tormach PCNC 1100 - Speeds & Feeds, new fixture table and more! Ch. 23
saunixcomp
2,279 views
General shop update - discussing speeds and feeds for the tormach (based on GWizard), the Series III upgrade, my fixture table, new tool storage and more!
-
Tormach PCNC 1100 CNC Mill - New Fixture Table! Ch. 22
saunixcomp
4,666 views
An introduction and overview of my new Tosa Tool Tormach-compatible Modular Fixture table! Approx 33x16x0.75" with 1/2x13 tapped holes and 0.5" bored alignment holes both ...
Advertisement
Play all(132)