s1dare

Izdelan je bil model programiranja NC struženja, ki bazira na metodi genetskih algoritmov. Slika na naslovnici predstavlja nekatere faze animacije gibanja orodja v takšnem modelu NC programiranja struženja. Razviti model bazira na metodi genetskega programiranja, je inteligenten, deluje autonomno, ročni posegi v sistem niso več potrebni. Objavljeno z dovoljenjem Laboratorija za inteligentne obdelovalne sisteme pri Fakulteti za strojništvo Univerze v Mariboru.
Model of NC turning programming was developed based on Genetics Algorithms. The cover figure presents several stages of cutting tool path in NC programming of turning. Developed model is based on Genetic Programming; it is intelligent, autonomous, manual intervention is not needed. Courtesy of Laboratory for Intelligent Manufacturing System, Faculty of Mechanical Engineering, University of Maribor.

less