rumblfmp's channel
Loading...
14
subscribers
32,799
video views
Uploaded videos
1-10 of 10-
Milling a mold from Obomodulan 710
rumblfmp
245 views
This shows the fine milling pass of a mold made with Obomodulan 710.
-
MVI_3281.AVI
rumblfmp
52 views
Little contraption to show the usage of servo motor from Mindstorms NXT 2.0 with linear actuator being used. This shows approx. how fast you can move with these little thin...
-
MVI_3280.AVI
rumblfmp
53 views
Lego servo motor on Mindstorms NXT 2.0.
Just to show what the Lego servo can and cannot do.
The motor is not controlled when the program runs (which is OK since that was ...
-
Elanimal on steroids (USBCNC)
rumblfmp
689 views
Upgraded Elanimal: new motor drivers and USBCNC allow speeds up to 7 m/min.
This shows a small piece of rough milling a 3D part in Obomodulan 302 with a full carbide 4mm b...
-
demo-2.avi
rumblfmp
4,252 views
Quick demo of an Attitude Indicator for FlightSim, one of the instruments of an aeroplane.
This is not the full AI, just those components to show the functions of the servos.
-
Ligfiets race Sloten, 13 April 2008
rumblfmp
1,254 views
This is part of a recumbent race organised by the NVHPV (http://www.ligfiets.net) filmed with a Helmet Camera.
Camera operator: Bob Vroeg
Editing: Hans van Vugt / Hans ...
-
Milling disc for disc brake on Elanimal
rumblfmp
12,273 views
Milling special discs for a Rohloff hub made from Aluminium, these will be ceramized by Ceradure (www.ceradure.com).
Milling is done with a HF spindle at 16000 rpm with ...
-
Milling a PCB for the tool length indicator
rumblfmp
996 views
As part of a project (see http://www.myvoice.nl/freesmachine/nulsteller.php?lang=en) I had to create a little PCB to hold the contacts (hardened steel balls) in place.
T...
-
Elan mill routing Balsa wood controlled by EMC2
rumblfmp
10,769 views
Still building our own CNC mill I wanted some quick results so I attached a 80x80mm alu profile with a Dremel hold in place by rubber bands (I did say quick result...). The...
-
Elan mill pen-plotting controlled by EMC2
rumblfmp
2,216 views
This is the first test on our home-made CNC mill. Before ruining a 2k$ milling spindle I started by mounting a pen to do some pen-plotting.
This is still the building phas...
Advertisement
About rumblfmp's channel
more
less
Play all(10)