rblackwell2771's channel
Loading...
34
subscribers
6,325
video views
Uploaded videos
1-10 of 23-
mechanical engine "unconventional"
rblackwell2771
24 views
Just showing a little of what can be done with scrap. One man's junk is my treasure. Ps i shouldn't be building this thing since it is impossible and i am wasting my time. ...
-
DSCN0533.mpg
rblackwell2771
149 views
i would like advice on this phase lock loop. Dave lawton's
-
DSCN0532.mpg
rblackwell2771
50 views
just a simple Hydroxy cell +-+-+ type config spaced at 1/32" the work really well with rain water and higher voltage like 60v or so. I will show these in action soon.
Anyo...
-
DSCN0440.mpg
rblackwell2771
207 views
just a peek into my world. i talk of my gravity engine project at the end.
-
single disk fogger running 6hp engine
rblackwell2771
2,203 views
just showing that a simple fogger modified can supply a great increase on run time. The delivery tubes do need to be warmed somehow to make this work well cause the vapor t...
-
amp reading and magnetics
rblackwell2771
243 views
In this video i show that magnetic north is on the bottom of the rod "the intake of air/fuel into the reactor" wether it is north to south or east to west. the rod is still...
-
geet rich mixture and magnetic orientation 2.wmv
rblackwell2771
126 views
this is just second part of a continuous video I show the rod at the end of it and can hold the front of the rod that is very cold. i think this is due to an endothermic re...
-
geet rich mixture and magnetic orientation.wmv
rblackwell2771
602 views
just a video segment showing my results using a very rich air/fuel mixture to the reactor. runs a lot cooler. also i believe my 1/2" inner tube with a .430 id "t-304 is to ...
-
short geet reactor revving and idling part 3
rblackwell2771
706 views
this is the 3rd segment of the 30 minute video. I am finally figuring it out i think. i have it now that i can get it to rev or idle by just adjusting the throttle on the ...
-
short geet reactor revving and idling part 2
rblackwell2771
185 views
this is the second segment continuing. In between the carby and the reactor is a 1/4" compression nut have a funnel like shape pointed into the reactor. This helped a lot f...
Advertisement
About rblackwell2771's channel
more
less
Play all(23)