proplinerfan's channel
Loading...
30
subscribers
34,424
video views
Uploaded videos
1-10 of 26-
DC-6 Motor Mount Bayonet Test 02-JAN-2012
proplinerfan
430 views
This is a the very first test of the bayonet like motor mounts of my 100" / 2,5m DC-6 RC Model. Since the wing with the four nacelles is quite difficult to transport I deci...
-
DC-6A G-APSA RC Model Nose Gear Door Tests
proplinerfan
708 views
This is a test of the Nose Gear Doors of my 100" DC-6A Model. The Gear Doors are actuated by an .8mm piano wire, so no extra Servos are necessary.
The downside is: due to ...
-
DC-6A-NoseLandingGear-Mar2011.wmv
proplinerfan
1,022 views
This is the final version of the nose landing gear of my DC-6A model. It now incorporates a smaller retract servo (Hitec 7775) and the nose wheel steering servo (Graupner C...
-
DC-6A Rudder Test with flying Tab
proplinerfan
770 views
This video shows the rudder with the fully functioning flying tab of my scratch build DC-6 with a spanwidth of 2,5m (100"). The rudder movement in the air will be supported...
-
Speed Brake Device in Cessna
proplinerfan
920 views
This Video shows the Arduino driven Speed Brake Device for JBs DC-9 mounted in my 2,1m Cessna 182 where the flaps go down with the down going aileron.
More: see here htt...
-
DC-9 Speed Brake Aileron
proplinerfan
663 views
This video shows the little Arduino device that is able to allow the speed brake in the wing of an airliner RC Model to be used as an aileron helper like the full scale pla...
-
Jeti Sensor based on Arduino Mini Pro Board
proplinerfan
1,765 views
This is the final test of the software that can be used as a basis for a Jeti Duplex Sensor. The software on the Arduino Mini Pro board can be used to send information to t...
-
DC-6 Main Landing gear Mockup
proplinerfan
1,888 views
This video shows the actual landing gear of my scratch build DC-6 with a spanwidth of 2,5m (100"). The sailwich was replaced in the meantime so that it runs even smoother.
...
-
DC-6 Arduino Gear Door Sequencer Mockup
proplinerfan
2,935 views
This is the extended Version of the Gear Sequencer I posted yesterday. The Arduino software I programmed is able to use pretty much unlimited Servos for the Gear now. Actua...
-
DC-6 Gear Sequencer Mockup
proplinerfan
681 views
The DC-6 had a special way of retracting and extending it's landing gear. I studied a lot of videos and took the timing. When retracting shortly after take off all three le...
Play all(26)