Uploaded videos
1-10 of 20-
demo
ollopa1
28 views
-
Last amplifier test
ollopa1
375 views
This is the last test of this dinky little amp. All I wanted to share is that it has enough power to drive a loudspeaker to a reasonable listening level. It's no floor-th...
-
Transistor audio amplifier v2
ollopa1
1,092 views
Well I don't know if it will come across in this video but I got much more power out of the amplifier with the following modifications: Increased supply voltage to 36VDC (...
-
Transistor amplifier
ollopa1
2,489 views
First test of an experimental transistor audio amplifier.
It works but the power output is not as good as I had hoped for.
Better luck to me next time!
-
FPGA based Moraff's Blast clone
ollopa1
271 views
Well after much hard work, this project is almost done.
I'm storing the original level data from Moraff's Blast on an SD card and loading it up from there.
There are so...
-
FPGA Moraff's Blast Clone v0.99c test
ollopa1
207 views
The new block collision detection algorithm works much better than the previous version. I even took it to the next step and erase blocks. Just a few steps remain.
-
FPGA Moraff's Blast Clone v0.1a
ollopa1
151 views
Here is the first test of the FPGA and MicroBlaze based Blast clone. I'm trying to come up with a very fast way to detect collisions between the ball and the bricks. This...
-
Independent rates
ollopa1
52 views
Here the six balls are moving with different velocities relative to each other. By toggling some switches, I can scale their overall vertical speed.
-
6 bouncing balls
ollopa1
132 views
I decided to see if my simple single bouncing-ball algorithm could be expanded to more balls. The video performance isn't changed at all. 6 balls bounce off the walls. N...
-
Bouncing Ball
ollopa1
74 views
Here's the first test of a bouncing ball. It works but the animation flickers a lot.
One ball was just not enough. Check out the 6-ball demo http://www.youtube.com/wat...
Advertisement










Play all(20)