Käyttäjän nappaa kanava
Loading...
3
subscribers
4,405
video views
Uploaded videos
1-10 of 12-
Constructing e-chain for my cnc router
nappaa
409 views
Drawn in ProgeCAD, tool paths generated with Cut2D. The material is 4 mm plywood.
-
Cutting out a connector plate
nappaa
186 views
It's a new connector plate for the electrical enclosure. At one point the router bit slid out from the collet and made the groove seen on the surface. I had to hit e-stop, ...
-
Routing a relay controller board
nappaa
180 views
Routing out a relay controller board for the hand router (and vacuum) to be turned on and off by Mach 3 via g-code.
-
Planing the surface and a little overview shot
nappaa
323 views
Planing the table surface took over half an hour, so to fight the boredom I shot a little overview of the whole machine while holding the vacuum hose.
-
Planing the machine table surface
nappaa
460 views
Using a 16 mm dove tail, the widest bit I have. It even planed one of the screw heads which was a little higher than expected. :P
-
Cutting out t-grooves for the machine table
nappaa
235 views
T-grooves are cut from the underside of the board. Tabs are left to hold the pieces together. The ends of the grooves are cut open in a separate run after the ends of the b...
-
Making the first chips
nappaa
40 views
Jogging across the board at 1000 mm/min. The depth is about 5 mm.
-
CNC art
nappaa
83 views
Pretty self-explanatory :p. I wrote the g-code to try out polar coordinates and for the giggles of course. The wire is for one of the limit switches, just temporarily hangi...
-
Doing some plotting with my cnc router
nappaa
77 views
It's finally running! The limit switch wires are a mess, tool holding is only half done and t-grooves for work holding must be added on a second layer of wood on top of the...
-
Deflection of Z-axis in Y-direction
nappaa
901 views
Measuring the deflection of my cnc-router build's Z-axis in Y-direction with a dial indicator. The first load is a 1,5 kg cordless drill, the second a 2,5 kg hydraulic jack...
Advertisement
About Käyttäjän nappaa kanava
more
less
Play all(12)