mystarstudios
Loading...
6
subscribers
10,894
video views
Uploaded videos
1-10 of 29-
Bell-Howell 33ST Gear Fix
mystarstudios
33 views
The take-up gear was freezing and would not start turning. After removing the worm gear I disassembled it and lubricated it. I used a #20 o-ring for the belt.
-
Brumberger 1503 Projector
mystarstudios
51 views
This a demonstration of THE NEW BRUMBERGER Model 1503 8mm movie projector.
-
Bell - Howell 33ST Gear Freezes
mystarstudios
36 views
I have tried several belts...round and square, but none seem to change the behavior of the gear not turning after the projector has been off for a brief amount of time. Giv...
-
Elmo ST-800 Chute Problem - Part 6 The Fix
mystarstudios
54 views
This video shows adding a small adhesive pad to the pivot leverage allowed the lever to push more on the chute t allow the film to continue threading threw and past the rol...
-
Elmo ST- 800 Chute Guide Stays Close - Part 5
mystarstudios
47 views
This is a troubleshooting video summarizing the finding.
-
Elmo ST-800 Chute Guide Stays Closed - Part 4
mystarstudios
34 views
This is a troubleshooting video showing the front and back of the projector while turning the control knob.
-
Elmo ST-800 Chute Guide Stays Closed - Part 3
mystarstudios
35 views
This troubleshooting video shows the movement of the linkage when the control knob is turned.
-
Elm ST-800 Film Chute Gude Stays Closed - Part 2
mystarstudios
29 views
Troubleshooting video
-
Elmo ST-800 Film Chute Guide Stays Closed - Part 1
mystarstudios
49 views
This is a troubleshooting video that shows the film chute guide in it's non-working closed state.
-
Ping Pong 1982 - DIY Super8 Telecine
mystarstudios
37 views
Super8mm DIY film transfer footage of my sons Adam 4 and Darrin 2 in 1982. Darrin is saved in the nick of time by his older cousin David after falling of the end of the pi...
Advertisement
About mystarstudios
more
less
Play all(29)