Uploaded videos
1-10 of 25-
Trix K4 N Scale Upgrade
mmagliaro
199 views
Overhaul of the Trix N Scale K4 4-6-2 Pacific including new motor, new gears, new tender truck pickups, LED headlight, and ground-down wheel flanges to run on code 55 track...
-
Trix N Scale K4 - Motor and Gearing upgrade
mmagliaro
1,559 views
N Scale Minitrix 4-6-2 K4 with upgraded Maxon coreless motor and new finer-ratio worm and compound gear. Top speed at 12v=112 scale mph (stock engine is 180!) Minimum spe...
-
Gear/Flywheel Removal
mmagliaro
10,833 views
This is a crude, but effective, way to get a flywheel off of an N Scale motor when even a wheel/gear puller fails.
It works better if you use a paneling nail (instead of...
-
Reworked Arnold N Scale GG-1
mmagliaro
4,392 views
This is an old Arnold N Scale GG-1. I put in a $12 Kato GM-5 motor, added pickups to the center drivers, and added weights on the pilot trucks. That solved the stalling, ...
-
T1 on Parade!
mmagliaro
3,078 views
Just some clips of my homemade N Scale PRR T1 4-4-4-4 around my layout
-
Walthers 0-8-0 Mashima + Gearhead Repowering
mmagliaro
4,270 views
My previous attempts, using the TinyTot motors and gearheads, produced good running results, but the various small TinyTot motors just could not stand up to hours of contin...
-
Tiny-Tot improved motor in Walthers 0-8-0
mmagliaro
412 views
My first attempt, it turns out, actually was a 25:1 gearhead, not a 5:1. I removed a planetary stage from it and shortened the gearhead housing to convert it to a 5.21:1. ...
-
Tiny-Tot 25:1 gearmotor in the Walthers 0-8-0
mmagliaro
1,394 views
The Tiny-Tot 8mmx10mm with 25:1 gearhead is only 15.5mm long total. I put it in this loco for super-slow (and actually TOO slow) speeds).
The video says that this is ...
-
N Scale Trix 0-6-0 w/Faulhaber coreless motor + 4:1 gearhead
mmagliaro
3,546 views
I remotored this stock Trix 0-6-0 with a Faulhaber 1212 (12mm diam, 12mm length) motor + 10mm 4:1 gearhead. With extensive frame reaming, it does fit entirely inside.
...
-
Super-slow Walthers 0-8-0 Demo
mmagliaro
1,040 views
Just running the engine on its own, this video demonstrates that with a new 5-pole OR with the stock 3-pole motor, this engine will run below 1 scale mph. The trick is to ...
Advertisement










Play all(25)