hi thre my name is jj i am intrested in your diagram were you make a cfl light burn but i want to know a ferrite core is it a magnet ; or can i use a magnet. I am new to this stuff and wuld like to relicate it if i may cause we have a shortige of electricity. and can i use something else instead.

thank you kindly

ha pat the last vid is private guy

Hey Patric,
Thanks for the sub and have you been experimenting further with the torid choke coil charging the 24V battery bank on the 12V 7AH SLAB's?
Dan.

balance my dear friend I have seen your work and am very interesting in the sr.badini seguirdor and I think and I'm sure your work take out the escavitud energtica to munch free people with the code I have something similar to yours but get more speed nesecito and more mechanical strength to try to make a three-phase motor generdor of 4kwtts we plan generation brake or load banks or domestic augend this generdor Badini the system with super 3g wheel and hall sensor may be possible have more than 2000 rpm with about 10 AMPEI or 1 or 2 hp of mechanical strength in this Moneto estmos modifying some details to try to work with 48vcd volajes of which is 4 batreias aluminum cylinder with a 5 inch and 6 magnets 2 enntre 6 inches divided the 360 ​​degrees planemos put the coils 1, 3 and 2 working arrnue ue suguire me and for your beautiful work felcitaciones

atte Jose Guadalupe Reyes
q roo cancun mexico greetings
I hope I'm as east as offshore boat
because my channel is regiom............

patric what i did was run a wheel on a singal iron
core stock ssg 1 trane add a wmw bifiller c shape that wmw fired 1 trane
in sreies hard to tune but works good
zz thanks you
guy

lol discharge time -tell all=zz

Glad you liked what you heard :o) Thanks!

Thank you for subscribing
Cheers
Vtech

Simply put, no. In theory it would work, in reality it does not. All
transistors are not exactly the same and in this situation, most likely, one
or two would draw more current than the others and then increase in
temperature which will draw more current, etc. Eventually smoke. You can
balance the current draw to some extent by puting a series resistor on each
but why. You're talking of using at least 10 parts to do the work of one.
Just use a proper transistor and do it right in the first place.

@min2oly The standrad ssg multi trane is a parallel setup
google paralleling transistors