mc2racing7emh's channel
Loading...
17
subscribers
180,813
video views
Uploaded videos
1-10 of 35-
Trochoidal Slot Cutting of 304 Stainless Steel on Tormach
mc2racing7emh
27 views
Cutting a slot in 304 stainless steel using a trochoidal tool path on a Tormach PCNC 1100 (Series 2). This video was recorded during feed/speed testing prior to the purcha...
-
304 Stainless Test Cut on Tormach PCNC 1100
mc2racing7emh
63 views
Test cutting a cylindrical pocket in 304 stainless on a Tormach PCNC 1100. It wasn't supposed to be a pocket; it was supposed to be a through-hole, but the material was lo...
-
Tormach PCNC 1100 - Trochoidal Milling of Prototype
mc2racing7emh
69 views
A prototype being cut from 6061 aluminum using trochoidal tool paths to start the center hole,
-
Short Segment of Machining Operation - One Piece of Stock, Two parts
mc2racing7emh
66 views
Tormach PCNC 1100 machining two parts in an array from one piece of stock. This is early in the roughing process. I was still developing my tool path generating process a...
-
6061 Aluminum Test Cut - Tormach PCNC 1100
mc2racing7emh
102 views
Test cutting 6061 aluminum on a Tormach PCNC 1100 Series 2. This is the fastest feed rate I tested. Here are specs:
Material: 6061-T651, .375" thick, 3.5" wide
Cutter...
-
Nylon Speed and Feed Test - Tormach PCNC 1100
mc2racing7emh
62 views
Cutting nylon 6/6 on a Tormach PCNC 1100 Series 2. I primarily adjusted the feed rate, but the rpm was changed on one pass (it was too low, so I changed it back). The det...
-
Tormach Duality Lathe - Facing Operation Cycle Time
mc2racing7emh
176 views
Facing the ends of a brass spacer. The length tolerance was ±.1, so the control of the fixture wasn't terribly important. The video was made for two purposes:
1. Measu...
-
Drifting in a Power Chair
mc2racing7emh
137 views
Jackass doing donuts and drifting in a Power Chair motorized wheel chair.
-
Heated Mirrors in Action - Merkur XR4Ti
mc2racing7emh
146 views
The heated side mirrors of this Merkur XR4Ti are demonstrating their badass capabilities.
-
Pneumatic (Air) Cannon Demonstrating Power and Aim
mc2racing7emh
136 views
The air cannon was assembled from scrap and trash parts from a warehouse. The barrel is made of the cardboard tubes from rolls of shrink wrap. The projectile is made of s...
Play all(35)