maxtek1's channel

Our NLX2500SY running a pretty easy part. Just pure vanilla turning with a dash of trepanning and some straight Caxis drilling and milling. 6061 al...

A 1984 vintage Hardinge 3 axis Superslant running a "Support-Wing Junction Fairing-locating pin". The part has a tolerance window of .0006 on diame...

I cant show the part but I can show the operation.

This is an involute spline push broach. The part requires that the spline form be rotationally o...

This is a 1/8 inch Guhring series 6511 drill drilling aluminum over 20x deep.

Not real challenging but I thought it had a little pucker factor. The...

This is a part we make by the thousands. The old process was to turn a ring with all the correct circular geometry and then split them in the mill....

This is not our facility but we made some of the tooling. This was done on a Okuma Horizontal. I think the part is for a 737 but I am not certain. ...

Machinery movers moving in our new Mori Seiki NLX2500SY lathe.

Would have been better if shot from a different angle. But I knew the camera was saf...

Phone Vid of my Hardinge Conquest after being moved to the new building and sitting for over a year. The noise in the background is my phase conver...