lomasck's channel
Loading...
2
subscribers
3,081
video views
Uploaded videos
1-10 of 19-
IMGP2604.AVI RC PULSE JETS imformation
lomasck
12 views
RC Pulse Jet.GERMAN INFERNO KIT.350kph Just some General imformation on RC Pulse Jets.Pulse Jets are legal here in Australia if done properly.
-
IMGP2564.AVI PULSE JET 50,000 VOLT BUZZ BOX
lomasck
24 views
My Best and final 50,000 VOLT BUZZ BOX for starting any Pulse Jet fastest.Uses about 3 amps with the electronic coil and 2 Amps with a no Balast Resistor Can Coil.Instant s...
-
IMGP2295.AVI Rob Frys RC Pulse Jet and Pressure Jets
lomasck
30 views
Rob Frys Pulse Jet test Flight of the first Legal RC Pulse Jet at Whiteman Park in PERTH WEST AUSTRALIA
-
IMGP2499.AVI Pulse Jet 200KPH
lomasck
142 views
Fast starting Pulse Jet.Most use 80% methanol & 20% Nitro for fast starting & a FORD modle T coil. Nitro gos off if left to long.Methanol wont.It is cheaper to.But y...
-
IMGP2498.AVI Flying My CL Pulse Jet on my own
lomasck
76 views
My first 3 faild flights of my CL Pulse Jet were because of several things.Bumpy grount.starting into the wind.not pulling the wire backon full ellivator at head hight when...
-
IMGP2494.AVI Control Line Pulse Jet Started and flown by me
lomasck
336 views
BMS Bailey Pulse Jet running on Methanol built about 30 years ago in West Australia.It still uses the same reed valve.I only use a 45psi weed killer bottle but I do use a v...
-
IMGP2476.AVI PULSE JETS
lomasck
41 views
Trying to improve all aspects of Pulse Jets without running them much as of the noise problem.And flying problem.
-
IMGP2475.AVI Valved Pulse Jets
lomasck
88 views
Trying to solve all the simple things that make pulse jets fun and sinple to use.In this case I used to fly Control Line Pulse Jets on my own for at least the past 10 years...
-
IMGP2474.AVI Valved Pulse Jets
lomasck
30 views
Someone try this with the tail pipe .Two thin tubes sliding over each other to change the length.That would be interesting.I think some have done this,like Rocket Man.
-
IMGP2470.AVI PULSE JET FUEL
lomasck
105 views
With the 3 thin valves ,a dry start was done by slowly bringing on the throtle until I had a ignition .If it was not running, slowly bring back the throtle a bit to the bes...
Advertisement
About lomasck's channel
more
less
Play all(19)