klsnr1's channel

Pump gas 632 CID 1970 Chevelle

2nd pass on dyno after some adjustment

Sneak Preview. Not finish yet.

. 1974 chevy nova, 355 sbc through dynatech splitflow mufflers

This is a old clip before exhaust got bolted up on fresh 355.

77' Chevy Short Wide Box, 383 cid stroker, TH350 trans built with all Hughes components, koleen steeles, alto red eagle clutches, hughes sprag, hug...

Just got tires on my new rims. Ready to Finally get it on the road soon!

this is my 1971 chevy c10 with a 350 3 speed standard. My father bought it when it was 2 years old in '73. Stored it in 1988 and never seen dayligh...

close race, good times, thanks for your help today everyone, tickling 10's...

Part 1 of my first pro street build. Hope you enjoy the video.

Crashes at Silver Lake Memorial weekend.This is a shortened version of the "Pilots of Silver Lake." This video utilizes SLO MO extensively. Beware ...

1983 chevy c10, new 3.73s and diamond plate dash benzel with gages.

1977 chevy cheyenne k10 1/2 ton 4x4 lifted 10 inches on 40 inch super swamper iroks new 350 motor bored .30 over to a 355 race motor hypereuctecic ...

big chief

www.alukannet.com

Procomp 210 64cc heads, Crane Blue Racer 234/244, Procomp 1.6 steel roller rockers, Pofessional products typhoon intake manifold...

1983 chevy c10, new 3.73s, diamond plate dash benzel with gages and 3 inch 40 series flowmasters with turndowns, Idel and rev.

383 Stroker Motor Installed, walk around

!984 Chevy K20 4x4 Pickup/ Turbo 292 Inline 6.

My buddy racing one of my other buddys

civic did not brake boost this time around

for race number one search this :

"Mustang 347 stroker vs Ho...

This is my 86 GMC. I have had the truck since I was 17. I have slowly built it into a drag truck. It is an all steel body, full interior, 355 sm...

85 chevy drag race street truck with nitrous

Start up of my 1969 Chevelle

here is my car. its a 1968 z28 camaro clone. it has a 350 stroked and bored .40 over so its a 388 i believe. it has brodix aluminum heads with 2.02...

NO HOLDS BARED

i have a 632hp street truck that me and a buddy decided to run threw a mud hole this run is in 2wd

This is my dad's 1988 Chevrolet Silverado. It's a drag truck. It has a 358 with a built 700 R-4 transmission, nitrous fosset plate a 250 shot bottl...

havin fun

doin work in a 86 c10 pickup truck runnin

We used a Dart Block completly machined by www.mesabalancing.com the cylinder heads were hand ported along with the intake and we tailored the igni...

Utah Muscle

NRE's Tom Nelson explains this partially finished1969 Chevelle. Awesome fabrication. Look closely and you will see far more than Tom has time to ...

Hey,

a few days after everything was finished the engine blew up with a broken piston.I will post a video about that later. Luckily the Engine-Bloc...