khabx6's channel

Got to see these run in Sarasota / Tampa bay back in the early / mid eighties.

We didn't throw our beer cans or bottles on the beach though. We just tossed them over the side.

Turtles didn't seem to mind either , more and more kept swimming up to the boat after the 1st 12pk.

nice job... recently did a CG Super Chip w/ a YS .91. Still waiting to maiden it. Is that a Sig Skybolt laying in the back ground? Got one of those for the boards shortly

yeah ..hey listen , those LG blocks.... are backwards... you've got the left / right swapped ...have you torn those out yet?

Not an experineced pilot nor builder aparently. From what I can see, has what looks like about 10oz of lead stick on weight stuck to the engine mount. Engine looks to be about a .60 size - plenty of weight in the nose for that one, with out sticky lead weights added. Watching this vid from s...

@lob287 ..... LOL yea, I'm 43. "A major 90's fan".. maybe because ya miss being a young 20 sumthing y.o. at the time. Missing those days myself.. definately better days back then compared to the present....WTF happened ? THIS AINT RIGHT

Why did you go through the trouble of cutting out the pink? Could of ironed

it on carefully with "low" heat , starting at one end and holding up on a slight angle as you worked it with the iron not trapping air as you worked it. Use 1/4" masking as a guide line. ?????????????

How would you ...

@anfnifarr yea thats a 1/4...209mph - 6.95, read and listen. 209mph / 6.95 sec. pass , #'s do not work for an 1/8 mile. 209 mph in an 1/8.....thats funny right there..don't care who u r ..lol

(not classic rock ...but blues).... where da ya think rock stems from?

Top end is fine. ( mixture screw) Your trying to set the bottom end mixture with the top end mixture screw. Set the bottom end screw. I hear it on intial start up, Sounds to "fat"- rich. In with the low speed needle setting like a 1/16 - 1/8 turn in. Small screw end of throttle barrell. Very ...

looking at the pic...I see what looks like a barrel type roller that holds the end of the

valve to the rocker. What keeps the valve retained in that barrel? Is it some type of

e-clip that holds the end of the valve .... or is it crossed pinned in some way ? Brought up beyond

the normal oper...

the ultimate late Friday / Sat night street racin' music - " LINEM - UP ! "

@TheGamingMagician

LOL!!!! . "Nack oh' mis" ...eh? (my old stomping grounds)....remember there was a rope swing

near the channel marker on the island side.... looking south from the crest of the bridge....also jumping from the bridge, .......

when the bridge tender had looked down for a m...

Nice!..Hope mine flys this well!

anyone from Massachusetts ? and if there is (from that period that use to frequent clubs)......know if they ever played @ the club.....The Lantern Lodge in Norton?...(early '70's)

@L6forlife26 no close though .Ru-Di-Lund (Rhode Island) 98.1 WCTK out of Providence small world eh? hehehe even smaller state huh haaaaa