James Bosma

DISCLAIMER: I do not own any of this material. it is all owned by Bob Rivers. I have permission to use it though

Experimental Rowland non-compression engine. It's built out of random junk & scrap from a local factory that closed down. The engine was built in a...

The 21:12 train departing from millbrook staition on the bedford to bletchley route

Millbrook station is a very quaint little village station si...

Homemade wooden frame gasoline engine

cold start on my t85 motorbike

My father built this model of a Atkinson Cycle Engine. Crankshaft and cam shaft are the same.

Video is courtesy of Scott Nyland. The race is 50 miles over the mountains in the back ground of this video. This course is one of the hardest cour...

Just a bit more of my ramblings and projects on a rainy day....

12 volt solenoid engine my father started to make around 12 years ago. I finished this project recently. Solenoid is a shutdown solenoid off a Kub...

Early 1920's Briggs and Stratton Model FH

Engine was missing a few parts when purchased

Too costly to purchase replacement parts

So did the next be...

1934 Briggs and Stratton Model B serial # 187

Different displays at the Qunte Flywheels Show 2010

Home-made 2 cylinder engine my father made

My fathers home-made gear less gasoline engine