janecki84's channel
Loading...
2
subscribers
959
video views
Uploaded videos
1-10 of 11-
TIM Application: Pea Size Method
janecki84
314 views
Pea size method spreads more faster than rice grain method did, but with pea method I felt i ran into the same issue as the line method. There is just too much TIM in betw...
-
TIM Application: Rice Grain
janecki84
129 views
Rice Grain works very well. Better than single line, but could have a draw back. This method seems to not spread enough for full coverage, but should spread enough to cove...
-
TIM Application: Thinned with alcohol 2 of 2
janecki84
24 views
The TIM between these two plates was thinned with 91% isopropyl. It spreads fast, too fast. The Paste outruns the air and air bubbles quickly get trapped inside. This wa...
-
TIm Application: Thinned with alcohol 1 of 2
janecki84
16 views
The TIM between these two plates was thinned with 91% isopropyl. It spreads fast, too fast. The Paste outruns the air and air bubbles quickly get trapped inside. This wa...
-
TIM Application: Mixing TIM with Alcohol
janecki84
27 views
This does not work very well at all. While it did seem to thin out the Paste somewhat. See the next video of how poorly the spread is when you put the two pieces together...
-
TIM Application: Tinting
janecki84
123 views
Tinting did not work at all. If your surfaces are perfectly smooth there is nothing for the TIM to work into. Now even with the best lap it's going to be hard to get a CP...
-
TIM Application: Spreading
janecki84
28 views
This is the just the video of the surfaces joining. Nothing pretty, BUT it did it's job.
Dont ask what kind of paste it's irrelevant. But it's a mix of dried Tuniq TX-...
-
TIM Application: Spreading Attempt 2 of 2
janecki84
39 views
Put this video to show how hard it was to spread on a prefectly flat surface. Really would not reccomend it, even though it did a decent job when the surfaces were brough...
-
TIM Application: Spreading Attempt 1 of 2
janecki84
49 views
Put this video to show how hard it was to spread on a prefectly flat surface. Really would not reccomend it, even though it did a decent job when the surfaces were brough...
-
TIM Application: Dual Line method
janecki84
54 views
I dont remember where I saw this one Reccomended, but DONT. There is just FAR too much TIM between the two surfaces. The lot that gathers in the center actually gave me a...
Advertisement
About janecki84's channel
more
less
Play all(11)