ilikec's channel
Loading...
5
subscribers
14,653
video views
Uploaded videos
1-10 of 21-
MVI 03141
ilikec
18 views
-
MVI_0312[1].AVI
ilikec
13 views
-
MVI 02151
ilikec
45 views
-
MVI 02141
ilikec
40 views
-
MVI 02011
ilikec
42 views
-
SUGINO H6 with CENTROID CONTROLLER
ilikec
29 views
Retrofitted Sugino H6 running a small production job drilling a #7 hole and rigid tapping 1/4-20 .44 deep.
-
1.25 APKT endmill on RH-30
ilikec
114 views
Cutting the periphery of an A-36 steel part. Approximately 1.3" thick. 1100 RPM, 16-20 inches a minute
-
Cutting Phenolic Gears
ilikec
240 views
YUASA 5C indexer, run by M code from Milltronics RH-20. 32 DP, 72 tooth phenolic gears are replacements for damaged units in old instrumentation.
-
drilling 2 inch holes
ilikec
334 views
High value job : gingerly drill 2" holes 12" deep in large aluminum block. Ugh, 36 minutes a hole. 42 holes means 20+ hours. We can;t afford a single misstep though...
-
Braining
ilikec
61 views
Young GROCK getting some rounds out. Hits his head too. Gosh, that gotta hurt.
Advertisement
About ilikec's channel
more
less
Play all(21)