Car Repair And Troubleshooting
Loading...
496
subscribers
1,934,829
video views
Uploaded videos
1-10 of 73-
Dodge Omni Shift Tube Bushing Replacement
ifitjams
234 views
After I manufactured a new bushing for the rod on the shifter tube (see http://www.ifitjams.com/linkage.htm ) I wanted to see it shift through all 5 gears and reverse. I've...
-
Shifting Dodge 5 Speed Transaxle with Homemade Shift Rod Bushing
ifitjams
234 views
The shifter rod bushing on my 1986 Dodge Omni failed, and nobody sells these parts anymore. Since I couldn't buy a new rod or rod end for the shifter tube, I manufactured n...
-
Excavator Bucket Rebuild Walk-Through
ifitjams
23,892 views
This Caterpillar bucket from a Cat 325 Excavator was rebuilt from the ground up, including the sides, grouser bars and wear block (to be installed). The shanks were also bu...
-
Welding Grouser Bar On Excavator Bucket
ifitjams
6,152 views
Welding video (with and without filter) of grouser bar being secured to a rebuilt excavator bucket for a Cat 325 Excavator.
-
Troubleshooting when the Car Won't Start - An Interactive Flowchart for Car Starting Problems
ifitjams
41,185 views
A look at the interactive flowchart for when your car doesn't start. The approach is to work towards the solution through the process of elimination. The flowchart is poste...
-
Cutting Out U-Joint With Torch
ifitjams
4,224 views
Old axle and drive shaft u-joints which are pressed and rusted into the shaft ears should be cut out when possible. Pressing them out may result in cracking and ear, as ill...
-
Grinding Out Crack To Prepare For MIG Welding Repair
ifitjams
2,900 views
Before MIG welding a cracked ear on an axle u-joint, you have to grind out a "V" for the wire welder to make good contact and fill in with new steel. http://www.ifitjams.co...
-
Welding A Cracked Axle U-Joint Ear
ifitjams
2,831 views
Pressing the bearing caps out of an old Jeep axle universal joint can crack an ear, especially if you don't get the whole snap ring out:-) But if all the stores are closed...
-
Grinding Weld on U-Joint Ear
ifitjams
1,959 views
After welding up the cracked U-Joint ear, it's important to grind the weld flush and inspect it for cracking. Full story on http://www.ifitjams.com/ujoint.htm
-
U-Joint Cap Knock Out
ifitjams
5,030 views
After cutting up an old U-Joint with a torch, you still have to knock out the pressed in bearing caps. Full procedure on http://www.ifitjams.com/ujoint.htm
Advertisement
Play all(73)