icfutur's channel
Loading...
13
subscribers
13,114
video views
Uploaded videos
1-10 of 13-
Bearing are on
icfutur
293 views
The bearing are on, it make it look like a electric hamster wheel,
now the built of the coils
-
My bedini motor, magnet 1 inch x 1/8 are in !
icfutur
5,742 views
The magnet are neodymium,
the North face the inside of the motor
it's pretty hard to put in place
glue with crazy glue
next step mount bearing
-
my home made bedini motor step 1
icfutur
1,291 views
built out of cedar,cut 8 blocks at a angle of 22.5 degree ,
bore inch hole at1/8 deep,
glue and screw at the assembly.
this is a long term project.
stay tune!
-
My Twin Newman Bike Engine
icfutur
1,263 views
Ready to go , work on 12 volts but not much power eventually i will put up to 36 volts for more Power and reduce the size of the carbon brush this will help too for initial...
-
My Newman Mini for my bike
icfutur
1,066 views
Brush system change and will be adapt for my pedal bike
-
My Twin Newman Engine part 3
icfutur
166 views
Second module attache ,Brush system modification, need more timing
-
My Twin Newman Engine Part 2
icfutur
1,062 views
Brush system upgrade, less spark, more speed, less noise, more power.
-
My Twin Newman Engine part 1
icfutur
411 views
First part, of my engine the objective is to mount it for bicycle of any size and serve as a helper on the ride , to keep going without to pedal , a lot have to be modified...
-
My Newman Engine 003
icfutur
307 views
Timing done, i add a diode to eliminate the feedback to the battery , next step boosting with capacitor to get more power
-
My Newman Engine 002
icfutur
391 views
Made out of a PVC pipe, shaft on bearing,
400 turn on the top as well on the bottom, double switch ,one for each coil, magnet core is neodymium, next step timing !!!
Advertisement
Play all(13)