henrols's channel
Loading...
50
subscribers
120,318
video views
Uploaded videos
1-10 of 16-
Servo module 1.avi
henrols
1,129 views
-
Mach3 circles.avi
henrols
462 views
Just a demonstartion of the effects of CV vs Exact Stop mode. Uploaded only for demonstration purposes during a discussion on backlash compensation and the problems involved.
-
2009-07-20.AVI
henrols
534 views
A rigged up testrun of the MAE642-0860 servo-motor. 4mm pitch ballscrew and 26/60 gearing. The axis velocity is 6000mm/min and acceleration is 400mm/s².
Note the extra b...
-
CIMG1681.AVI
henrols
604 views
Simple demo of a DC-servo system for Mach3.
Drives are Whale3 from CNCDrive.com, MAE642-0860 servo motors, AMT103V encoders with differential linedrivers.
The motor ve...
-
Abene 1
henrols
2,351 views
Initial 3 axis motion tests on a converted Abene VHF-3 knee mill.
Mach3, Smoothstepper, HP-UHU servo drives.
-
Small servo drive
henrols
1,427 views
This is a small Maxon PMDC-servomotor driven by my own little servo controler. PIC18F2431 and LMD18200 H-bridge, code written in Melabs PBP. This version takes serial comma...
-
AMT102 vs R35i.avi
henrols
1,227 views
Video showing the different behaviour of the AMT102 and R35i encoders.
-
HP-UHU High Speed.avi
henrols
2,423 views
This video shows an Indramat MDC 10.30D motor being run by the HP-UHU servo drive. The motor is accelerated to 1800rpm at 180rpm/s². The movie was shot with a Casio EX-FH20...
-
HP-UHU Encoder signals
henrols
1,424 views
Shows what the encoder signals looks like on the "inside" of the differential receiver on the HP-UHU. They are a bit jittery and I'm wondering if that may be the problem or...
-
UHU-HP testing
henrols
10,994 views
Video shows one of the first new UHU-HP servo drives available as kits for DIY-ers. This video is shot during inital testing so tuning is not optimal yet. Motor is an Indra...
Advertisement
About henrols's channel
more
less
Play all(16)