haaardyi515's channel

Race from a stand still

(INSIDE CAR)

JDM B16A swap

civic hatchback - EG

Spoon Sports P30 Race ECU

Vs

(OUTSIDE CAR)

Supercharged Thunderbird c...

PAPO TECH BUILT

Preview!!! Stay Tuned, Subscribe To See More Of This Integra!!

Stock K20a2

RBC Intake Manifold

S90 70mm Throttle body

Strup Race Header

Intake With Vstack Out The Grill

3" Exhaust

Kpro

408 Yates Stroker Motor for sale on racingjunk.com. Ad #2013549

9.40 off motor in foxbody coupe

First time testing the Mustang with the new 408 engine. Wasn't fully prepared for the signifigant loss of traction even with the drag radials.

Too...

A race between 1992 Ford Mustang Lx with 408c.i. engine and 2001 UltraZ chevy Camaro with 416c.i. engine, all motor race ( No spray, No forced indu...

Go kart on dirt

tapped

My buddy Paul talking smack about his Honda CRX. He is calling out all Mustangs! He has run a best of 14.71 at the track.

Shiftslow.com Winter Day runs:

Jesus Boost: Precision 6265 @25psi on Built motor

Slow_snake: Kenne Belle 2.2 @15psi

oscar_svt: Ported Blower. I/E

H...

40 roll.

http://www.honda-wiki.org/w...

http://www.honda-wiki.org/w...

Video car 96 integra with c5 swap civic is 93 sedan with jdm k20a

compilation of this car's trip from dyno to track

247 whp 156 tq on pump gas , full exhaust .. 13.1 @ 110 mph full interior dc2 , street tires

Sponsored by: http://www.empowernetworkla...

I built this b20 vtec setup with the money I earned through this proven system...

It literally ...

vernam test and tune

These are the motor and driveline specs...

Engine:

B16A2

JE 12:1 pistons (roughly 12.5:1 final comp with the flat face valves)

Eagle rods

ACL be...

My b20vtec hatch semi built, runing on shitty 91 oct gas and brand new 205-50-r15 tires. Had to granny shift the tranny, shift linkage messt up. I'...

CTR Ek vs Si Rockingham Dragway - 4/3/11

Launch with 205/50/15s at 32psi

civic vti b16a2 with aem cai, dc header and skunk2 exhaust 2.25'' from greece...

Lap round Alford track in my EK9 civic with passenger, lots of fun!

my ek9 on the rollers at Dastek

191.4bhp @ 8800rpm , woop!

I wanted to get a new pipe for the ride so I Tested this out to see if I liked it.

quick launch control by SPEEDWARE MOTORSPORTS

anoigei mia 1-2 ..popopo thorivo i skunk2

Не смотря на то, что Honda Integra DC2 несколько мощнее, чем Honda Civic EK9, не все решает мощность машины ...

Блог о легендарной Хонде Цивик ЕК9...

K20a EK hatch built by midwest automotiveworks

jordan having a blast with mates ek9

Jordan is stock apart from de cat, 2.5inch straight through exhaust and itr intake.

EK9 has spoon 2-1 downpi...

my k24ek vs k swap eg part 2.. 3rd gear pull this time

this was a 3rd gear pull... camera inside my boys k20 bubble.

900hp 10-second on a runway. hits over 270km/h and goes off the end of the runway!!!

Only in Motive DVD #3

4wd launch from 1000hp croydon racing built street gtr

98 jdm itr swap

stock bottom end

buddy club 3 high compression flat valves,camshafts

skunk2 68mm throttle body

edlebrock performer x intake manifol...

2000 Civic DX Hatch

98 spec JDM ITR Swap

vs

1995 Civic DX Hatch

97spec JDM ITR Swap

This is for you Derek!

Heads Up

Some quick footage of my all motor '98 coupe.

This is my poor mans type r on hondata itr ecu. p30 pistons, ran short on length so didnt wrap up 5th

Wrx bolt ons VS Civic poor mans type r. Civic is untuned a only going to 8k.

going from about a 50 kick the k20 pulls hard bout a car and a half but we only had time to shift gears 1 time

my hatch at the track runnin flat 14's with stock block and type r cams everything else stock