gorak142's channel

Is it legal to own full auto version of these guns in the Czech Republic and Slovakia?

So in Germany, the receiver is not considered the gun as it is in the United States? All you would need to do is press in a new barrel and you've got yourself a new Full auto VZ.

@go0fy11137 IT"S NOT A CHINESE MODEL AK. IT"S A CZECH VZ-58 GOOGLE IT.

It would be interesting to see how he would react if congress one day had to invoke martial law and he basically would be put on the same side of the police.

It looks like I'm missing the nut that screws into the main threaded post on those spacers to secure it to the cover thing. There is a nut that fits it, but it does not tighten down all the way. Could you tell me which nut goes over the main post on the spacer?

Hey what size are the two nuts that hold the radiator to the cover plate? I'm talking about the ones that go over the two threaded posts. I can't seem to find them.

Holy shit you look a lot like Mike Portnoy.

Hey do you have the torque specs for the bracket, caliper pins and the bolt holding on the line? for the front side

Well dont just stand there and yell, shoot the thing or scare it off!

You Look like Mike Portnoy.

Take that thing to a gunsmith now because it shouldn't be firing those two or three rounds when you take your finger off the trigger. Once you take your finger off the trigger it should stop. Your MG-42 is unsafe if it continues to operate like this.

I wouldn't mind being patted down by that Female TSA Agent.........

What do you think of The Singleton of Glendullan?

Piano Solo looks pre-recorded.

I happen to agree with the two posters below this one. The staff at this range is on a huge power trip. They just can't wait to find someone making the slightest infraction, and to throw them out for it. Much better staff/atmosphere at McMiller in Wisconsin.

Mythbusters needs to put this to the test.

Wouldn't a Double-Hook Trigger Accomplish the same thing as the "rate reducer"? It's to my understanding that this is what the Russians did with the Original AK-47 with a milled receiver- that they never used a rate reducer with their milled AK-47's but instead just used a double hook trigger?

I tried punching the pin out with a hammer and punch set in a WASR 5.45X39 kit and I ended up flattening the pin. Now I have to drill it out.

does a barrel with a matching serial number need to be checked for headspace?

What size brass nut is that?

Can't you also use a gear puller and a brass nut?

I'm not necessarily looking for a sweet cider, I just don't want it to turn out tasting like wine. I've had this problem several times from making cider in the past. Maybe I'm just not aging it enough.

Is that an Oxy-Acetylene Torch?

@lowlypeasant

Caller Id Spoofing.

Joe, Does the need to be completely taken apart to clean and before/after each use. I just ordered a pin-lock keg system, and was curious as to if I can just run PBW then sanitizer through the lines and be fine, or if I will have to take apart the fittings and sanitize those separately.