floush1337's channel

Test Gcode provided by Lampmaker. Find the code attached in the bottom. Notice the smooth acceleration. At some points something goes wrong. Sounds...

Thing: http://www.thingiverse.com/...

More 3D Printing coverage: http://www.techwall.net

0.17/0.085 layer height, Netfabb generated. Print ...

I had to turn the Z-stage away from the print because the print head touched the print. This behavior was repeatable (two prints before this one), ...

Print of http://www.thingiverse.com/... with an Ultimaker at:

Stock firmware, 0.17 layer height, Netfabb 150% speed + 400% live-tuning speed.