enigmaman1's channel
Loading...
12
subscribers
38,296
video views
Uploaded videos
1-10 of 19-
Bent Flexplate?? - Diagnosis part 4!
enigmaman1
269 views
Trying to determine if this flexplate is bent / broken. I have pulled all the wires at each plug while the engine is running to see if its a spun barring, removed the acce...
-
Bad flexplate diagnosis Part 3
enigmaman1
490 views
trying to determine if the flexplate is bent / warped on the 455. Attached is a video of the start-up and idle of the flexplate disconnected from the torque converter.
-
Disconnected Flywheel / Torque Converter
enigmaman1
340 views
I disconnected the flywheel from the torque converter and started it up. Still making the same noise as before. Its really loud under the car vs ontop. still a mystery!!
-
Removed Accessory belts - Knock is still there Olds 455 big Block
enigmaman1
144 views
Removed Accessory belts, knock is still there. Ive had people tell me its the Flexplate on the tramsmission. It is the stock one from the 307 and is now hooked up to the 45...
-
1986 Olds Cutlass Supreme - 455 Engine Knock
enigmaman1
273 views
I have about 8,000 miles on this engine build and have developed a bit of a kock. It started within in the past 50 miles and I havn't driven it since it started. I am not s...
-
Sputtering from Idle - 1986 Olds 455
enigmaman1
189 views
I cant figure out why it sputters and boggs like this during an idle blip of the throttle, could the carb settings be off?
-
Olds 455 Breakin Process! Gauges 5-24-2009
enigmaman1
88 views
I created this video at http://www.youtube.com/editor
-
Fuel Filter Air Bubbles - 1986 Olds 455
enigmaman1
605 views
Are these air bubbles normal coming though the fuel line to the carb? Or is there a leak in the fuel lines?
-
1986 Oldsmobile 455 Electric Fan Setup
enigmaman1
337 views
Trying to keep the Olds 455 cool with a 3 core full copper rad, 2- 16" electric fans (1900 CFM and 3,000 CFM) and 1 - 10" 900CFM fan, External Tranny cooler 1" x 19" x 6". ...
-
1986 Oldsmobile Cutlass Supreme with Olds 455
enigmaman1
765 views
Just replaced the stock dist weight springs and bushings for weights. it Revs up a lot quicker now. I have 18* BTDC at 800rpm and then 32* BTDC at 3000+rpm. Motor was revve...
Advertisement
About enigmaman1's channel
more
less
Play all(19)