edwilson1989's channel

First test flight of the airship. The system is a little on the heavy side so the airship is having to use vector thrust to direct a component of t...

This video shows my airship gondola being controlled by an input shield there is nothing smart happening. It is scaling the result from the potenti...

This show the servo actuating the propulsion boom. The motors are both turn on and are producing quite a bit of air flow.

This show my airship's servo actuating the propulsion boom. It is possible to see propulsion units moving.

This project uses an Arduino Nano (168) and an ADXL335 to determine if the breadboard is on flat ground. This module isn't calabrated properly yet ...

This was my attempt at cutting carbon fibre on a laser cutter. The part was for my final year project. Unfortunately the test was not successful as...

This was my attempt at cutting carbon fibre on a laser cutter. The part was for my final year project. Unfortunately the test was not successful as...

UOW Airship Mk2 frame being cut on a laser cutter.