donbscout's channel

Tightening the knot

Doubling the turks head

Tightening the turks head

Removing the knot from the tool...

Remove the slip knot from the back of the tool,

then lift bights over the bottom pins and remove knot.

Completing the knot on the tool -

We will put in the last two passes and the then double one pass to hold the knot's integrity

Tying the knot on the Tool

Introduction to the Turks Head Recipe

Showing surface pattern, progression from pin one to four etc. and over and under crossings as we go. There a...

Introduction to the Turks Head Tool - This particular tool has a band of tape upon which the pin numbers have been written for clarity.

Preparing the cord on the Turks Head Tool... Start with about 2M of 1.6mm nylon cord. The ends of the cord have been melted with a flame and made i...