capefarewell's channel
Loading...
10
subscribers
25,589
video views
Uploaded videos
1-10 of 10-
Whitworth Quick Return (#3/3), A general description
capefarewell
889 views
Whitworth quick return, mounted on a crank planer.
This is an attempt to describe how the "Whitworth Quick Return" operates on the Crank Planer.
-
Whitworth quick return (#2/3) set to a long travel.
capefarewell
1,456 views
Whitworth quick return is mounted on a Crank Planer.
The Block on the bull gear (holding one end of the connecting rod), is set to the maximum outer radius.
The bolt th...
-
Whitworth Quick Return - (#1/3) set to a short travel.
capefarewell
7,960 views
Whitworth quick return mechanism is mounted on a Crank Planer.
In this example, the connecting rod is rotating on a small radius (close to the centerline of) the bull...
-
Tramming a planer (the bottom of the vise)
capefarewell
165 views
Tramming a Planer. Checking the bottom of the vise, to ensure that the planer is within a few tenths. The runout is acceptable for an old (1870s, more or less) Crank-planer.
-
Cutting the top of a dovetailed fixture
capefarewell
2,472 views
Planer is taking a light (.008) skim cut off the top of a block of steel. The block is for an Aloris AXA size toolpost (mounted on the Hendey lathe). The block was flycut...
-
cutting a block of steel
capefarewell
437 views
After a few repairs (replaced: Clapper box pin, Lever arm pin, Connecting rod (bronze bushed), Connecting rod bolt located beneath table), and a change in lubricants (had ...
-
Hendey T&G Lathe, cutting the base of a bevel gear blank
capefarewell
3,096 views
Cutting the base of a Bevel gear blank (must be very flat), on a Hendey tool & gagemakers lathe.
The blank is held in a 3 jaw cushman chuck, & supported by the stea...
-
Hendey tool and gagemaker lathe
capefarewell
2,178 views
Hendey tool maker and gage makers 9" lathe (9x18"). Made in 1941, it has the equipment it was originally issued with (3 & 4 jaw Cushman chucks, 2 faceplate, collet set, dr...
-
Crank planer, made in Conn. making chips of steel
capefarewell
2,301 views
Crank planer cutting a block of steel.
-
Crank Planer cutting steel
capefarewell
4,635 views
Crank Planer (Alfred E. Moore Machine Co. Winsted Conn) squaring steel block. The Motor is 3/4 hp running at 1750 rpm attached to a 1:10 gear reducer giving a shaft speed ...
Advertisement
About capefarewell's channel
more
less
Play all(10)