bmanTCoiler's channel
Loading...
35
subscribers
45,882
video views
Uploaded videos
1-10 of 14-
SKM50GB100D DR SSTC testing
bmanTCoiler
521 views
2 videos joined together, was getting to many primary shielding hits. The ceramic floor seems to be a poor choice for ground strikes. :)
Strike target in second video is...
-
Experimental DRSSTC with Gen1 brick
bmanTCoiler
371 views
SKM50GB100D IGBT Half-bridge
220kHz Secondary w/topload
~700amp according to o-scope (7xpulsed rating)
(horrid tuning, still getting to grips with operating the coil an...
-
IGBT Explosion - DRSSTC run.
bmanTCoiler
4,408 views
Slowly ramping up Pulse Width.
Blew up my half-bridge pushing the little IGBTs as far as I could. Though I believe what caused them to explode was the fact that I quite id...
-
DRSSTC-tuning
bmanTCoiler
446 views
tuning...
Half-bridge IRG4PC50W (MUR1560)
2200uF 450V
66nF 4kV MMC WIMA FKP-1
-
Sparky SSTC
bmanTCoiler
473 views
Half wave rectified half-bridge TC now sporting IGBTs. Going for spark length, much tuning still required.
-
Interrupted Solid State Tesla Coil
bmanTCoiler
498 views
Half-bridge tesla coil, Full-wave rectified with 1000uF 450V electrolytic smoothing cap.
This coil was tuned from the beginning to be a CW coil, due to this reason it can ...
-
CW SSTC - Power Arcs!
bmanTCoiler
1,213 views
~40cm Arcs, CW flame ~30cm
Overhaul of sstc from previous videos:
New Secondary with torroid: F=~220 kHz (50cm high 10.6mm wide LDPE, 27 AWG wire)
Now sporting full-...
-
PLL SSTC Half-wave rectified
bmanTCoiler
646 views
Same coil as before, half-wave unfiltered rectification (MUR1560).
Sparks are now in the 25cm range (secondary coil form 19cm). Still in the kW range I suppose.
htt...
-
2.2 kW PLL SSTC CW
bmanTCoiler
28,462 views
Just finished up this coil, haven't had any time to tune primary. Haven't meassured current but trips 10 amp breaker every other time I apply power. So at 220v its around 2...
-
24vRoyerSSTC
bmanTCoiler
156 views
Play all(14)