bjcrouch2's channel

I remember when My 99 bonneville hit 100k. It now has just over 130k and is still going strong. I hope to get at least 300k out of it. I love that car!

@bjcrouch2 but you can sharpen that raised part if you want. it won't hurt anything. I usually balance the blade on a screwdriver. Over all good vid. Thanks for doing what you're doing Eric. I've learned alot from you.

it looks like the wheels are attatched to plastic, unless this is the same type or quality of plastic Honda uses on their HRX series...yikes.

if it starts and runs very briefly like that it's most likely a dirty carb. Tecumseh engines are famous for that. clean or replace the carb and you should be good to go.

personally, I like my kirby. Bought it at a pawn shop for $50 then went to a local vac shop for parts to fix it up. total came to just over $100 for a VERY powerful, SOLID vacuum that is made mostly of METAL not cheap thin plastic. If you're going to spend $500 on a vacuum, buy a refurbished Kirb...

This mower has a BBC which means that the engine will run without the blade turning. Although non BBC mowers need to have the bar held down to start I have not seen a mower yet with a BBC that needed the bar held down to start. The bar on this mower is used to start the blade. once the engine is ...

for small residential properties I have found a John Deere 14sb with a gator blade and mulch plug installed works better than anything else I have tried.

If you make a 6.5 hp gasoline powered paper shredder...you might be a redneck.

This is awesome though. :)