Uploaded videos
1-10 of 11-
Removing hot guitar amp tubes with tube glove
aztechmusic
2,073 views
http://aztechmusic.com
Electro-Harmonix tube glove used to remove hot tubes safely. Find more tech tips at website with newsletter.
-
Guitar Amp Repair Audio Signal Generator Loftech TS-1
aztechmusic
8,983 views
http://aztechmusic.com
This is a demonstration of the Loftech TS-1 audio signal generator. Very easy to use, sturdy, and accurate.
They are still around on the net. ...
-
Tube Amp Bent Tube Pins How to straighten
aztechmusic
1,583 views
http://www.aztechmusic.com
Use care replacing your pre-amp tubes. If you bend a pin, carefully straighten
using the following procedure. Learn more tips on how to get...
-
Fender Amp Repair Dirty Volume Pot Stinky Tubes Part 2
aztechmusic
28,603 views
http://www.aztechmusic.com
Amp comes in shop very dirty and needs tubes. Video shows checking out the amp and cleaning pots. Visit website for more info.
-
Fender Amp Repair Dirty Volume Pot Stinky Tubes Part 3
aztechmusic
12,278 views
http://www.aztechmusic.com
Amp comes in shop very dirty and needs tubes. Video shows checking out the amp and looking at the waveforms on the scope. Using a drumstick ...
-
Fender Amp Repair Dirty Volume Pot Stinky Tubes
aztechmusic
12,766 views
http://www.aztechmusic.com
Amp comes in shop very dirty and needs tubes. Video shows Gary checking out the amp and looking at the waveforms on the scope. Visit website...
-
Korg Synthesizer MS-10 Pitch Bend Repair
aztechmusic
2,821 views
http://www.aztechmusic.com
Gary explains the voltages present on the pitch bend pot and how to determine it is working correctly. Use of a volt ohm meter is explained in...
-
Safety Training for Music Electronic Techs
aztechmusic
3,689 views
http://www.aztechmusic.com
Disclaimer and proper training procedures for musical electronic techs is a must. Seek out an experienced tech near your home or attend train...
-
Music Horn Diaphram Repair Ohm Meter
aztechmusic
9,387 views
http://www.aztechmusic.com
How to use an ohm meter to tell if your high frequency driver is defective.
-
Guitar Amp Repair Stand
aztechmusic
2,861 views
http://www.aztechmusic.com
Simple to build sturdy amp stand for repairing your gear safely.
(2) 2 x 6 inch lumber
(2) 2 x 4
(2) 4 x 4
length, whatever you need.
Advertisement










Play all(11)