anthonyberry4's channel
Loading...
71
subscribers
199,645
video views
Uploaded videos
1-10 of 28-
2010 MazdaSpeed3 Rev with Muffler Delete, 2nd cat delete, and stock resonator in place.
anthonyberry4
1,760 views
Just like the title states...
This video is after the Street Unit testpipe in place. The rear axle-back was straight piped/ The OE resonator is in place.
Sounds prett...
-
S256 BorgWarner STi vs. 2.0 WRX w/ TD06-20g both on Meth street race to 145mph
anthonyberry4
1,514 views
Well just as the title states.
The camera car is a 2.5RS with a full STi swap including interior and everything out of an 04. Borg and Warner S256 at 21+ psi with 660cc of...
-
2010 MazdaSpeed3 with OEM Muffler Delete, Stock everything else
anthonyberry4
581 views
The car is basically stock with a Cobb SRI, AWR Rear Motor mount, and the rear muffler/axle-back replaced with a straight pipe. Single exit out the dirvers' side.
Stock re...
-
Fully built Subaru 2.55 STi hybrid hitting the quick 2-step with antilag
anthonyberry4
3,566 views
Quick demo of the 2-step antilag i just turned on.
Sorry guys the e-cutout was open so there's no visible flames.....shooting them under the car.
But you can see the...
-
Fully built WRX going down the track with the VF39 running unrestriced
anthonyberry4
1,292 views
Test and tuning to setting up to "try" breaking the VF39 (Stock STi turbo) 1320 record.
Car ran a 7s or so this pass with no traction in first and a bad launch. It's on ...
-
2.55 liter Fully Built Subaru WRX STi hybrid with Big 280 Cams at Idle
anthonyberry4
3,273 views
Sounds good for a little 4 cyl.....the microphone deafened it a little its a lot louder and deeper than depicted.
Short and sweet:
Built/Ported/Angled heads with +1mm ...
-
First idle of my new fully built STi hybrid with 280 cams, CPs, Pro-Rods, +1 Valves
anthonyberry4
1,380 views
The run of my new fully built motor. Doing the 20 minute idle before the oil change to get rid of all the assembly lube.
Mods:
Custom CP pistons 100mm (bored .020 over...
-
WRX with a Brian Crower 280 Cams EJ257, 9.1 comp Hybrid, Idle vid, cutout open/closed
anthonyberry4
7,299 views
It's an older video....way old actually.
Someone wanted to hear the 280s so i posted an old vid.
In the vid it had WRX heads with cut valves (shimless buckets), BC 280s,...
-
Street racing, track, and a little everything complation.
anthonyberry4
1,127 views
Just some crap i got off my camcorder thats been on there for a while and the races from last Saturday.
-
Modded Yamaha VMax Idle/Rev Video: Camed, 4-1 Kerker w/comp baffle, 4 K&Ns, Dynojet Stg. 7
anthonyberry4
3,229 views
Just an idle and rev video of our new toy. Yamaha VMax that has been cammed, quad K&Ns, Kerker 4-1 2.5" with comp baffle, clutch, and Dynojet STG7 kit.
I'm keeping this on...
Advertisement
About anthonyberry4's channel
more
less
Play all(28)