WarpLimit's channel

@GaZaY0UTHchris Exactly what I was thinking. The 757 already has the landing gear height to allow large-diameter engines, and the fuselage is the same diameter. A shortened 757 make a lot more sense than trying to extend the 737 design again.

@LOLYouGotTrolled666 Just sitting there, how can you confirm that gravity follows an inverse-square law in Newtonian Physics? How can you confirm that if it weren't for air resistance, objects would not reach a terminal velocity when falling to Earth? Science has provided these answers, but you...

@proudfootz The buildings did NOT fall at free-fall speed or near free-fall. The problem for you: near free-fall would be 10% or 20% over free-fall speed. But 100%+ over is NOT near-free fall. Do you understand what this means? Caps again: SIGNIFICANT potential energy was available to colla...

Good work! It's funny how the 9/11 nutjobs continue to grasp as straws in a desperate attempt to keep the conspiracy theories going. Reasoning, video evidence and scientific arguments are not going to convince them that it was the 19 hijackers who caused all the death and destruction. Dark for...

@reykool Where are the interviews with the "terrorists" who are still alive? One would think it would be all over the news. No wait, the media is in on it. But then Al Jazeera should still broadcast the inteviews. Ah, but they are a puppet organization of the West. Then surely Iran, North Ko...

@88Conr88 A lot of the dust was from the huge amount of drywall used in the buildings. You can crush the plaster in drywall into dust with a hammer. When the top section of each tower collapsed, the debris built up on the floors. This caused downward as well as outward pressure: as more debri...

To answer your question of pressure: the top part of the south tower did not fall away from the rest of the building. It started to lean, and then the whole block starts to fall. It's not as easy to understand what you're seeing, because it continues to rotate as it falls. But 90+% of it stil...