TFMTraining's channel
Loading...
71
subscribers
37,251
video views
Uploaded videos
1-10 of 14-
Guild D4-12 Dreadnought in Natural Finish
TFMTraining
320 views
Guild D4-12 Dreadnought in Natural Finish.
This video was made as a demonstration for selling the Guild on Ebay.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=1606...
-
TFM - Plane Machining in Mastercam X5
TFMTraining
873 views
Taken from our training CD on Multiaxis machining. This lesson covers selecting a tilted plane for machining and creating a facing toolpath to mill down the rough stock. L...
-
TFM - Curve 5X Line Control on Mastercam X5
TFMTraining
649 views
5 Axis toolpath programming video on Mastercam X5. Shows Line Vector Positioning Control using the Mastercam Curve 5X toolpath. One of over 120 videos on the new 2 CD set...
-
EAA Oshkosh 2008 F22 Raptor and P51 Mustang
TFMTraining
355 views
These were taken at the 2008 EAA fly-in in Oshkosh Wisconsin. The highlight of the show was the F22 Raptor, followed by a Heritage Fly-By of the F22 and a P51 Mustang.
-
Ibanez MC-1 MIDI Electronic Guitar Controller
TFMTraining
379 views
This is the interface box for the Ibanez IMG2010 guitar controller. This will convert the signal from any Roland 24 Pin MIDI guitar (GK-1, GK-2, GR303, GR707, ect...) This...
-
TFM - Dynamic Open Pocket in Mastercam X5
TFMTraining
5,744 views
This shows you how to do a Dynamic Open ended Pocket in Mastercam X5. This is 1 of 22 lessons on the TFM Mastercam X5 2D HST training CD.
http://www.tipsformanufacturing.co...
-
TFM - Mastercam Solid Modeling - Extrude
TFMTraining
3,467 views
Covers the basics of Mastercam's Solid Model function "Extrude" to cut a profile into the part and also to add a new body part to the model. "Trim To Selected Face" is th...
-
TFM - Mastercam Solid Modeling Preview
TFMTraining
5,407 views
This is a preview of the Surface Design training CD. It focuses on creating a Ruled Solid, a Swept Solid and how to subtract them from each other. Available at http://www...
-
TFM - Mastercam Surface & Solid Modeling Preview
TFMTraining
5,912 views
This is a preview of the Surface Design training CD. It focuses on creating a Loft & Ruled surface and comparing them with each other. Available at http://www.TipsForCadC...
-
TFM - Introduction to the Mastercam X Interface - Part 3
TFMTraining
1,165 views
TipsForCadCam.com - An introduction to the Mastercam X Interface. This is a sample from one of our Tips For Manufacturing Training CD's Mastercam. This covers Hot Keys and ...
Advertisement
Play all(14)