ASACLEAN
Loading...
2
subscribers
2,930
video views
Uploaded videos
1-10 of 16-
ASACLEAN General Purging Procedures For Injection Molding
SunPlastech
37 views
-
ASACLEAN Purging Compound Extrusion Procedures
SunPlastech
64 views
-
ASACLEAN Purging Compound Hot Runner Cleaning Procedures
SunPlastech
42 views
Cleaning of Hot Runner systems using unfilled grades of ASACLEAN (see grades below) may now be performed. ASACLEAN that is run through hot runner channels will combine with...
-
ASACLEAN Purging Compound Pre Maintenance Cleaning
SunPlastech
13 views
Cleaning prior to a maintenance shutdown can require significant time and effort. Using ASACLEAN prior to a maintenance shutdown will greatly reduce the resources required ...
-
ASACLEAN Purging Compound Sealing/Shutdown/Startups
SunPlastech
24 views
Most thermoplastic resins when left in the barrel, even for a short time, are likely to degrade and become a cause of product contamination. To prevent contamination or dep...
-
ASACLEAN Purging Compund Nozzle hang-up - Color or carbon
SunPlastech
5 views
Raise the temperature of the nozzle about 68 - 86 °F, (20-30 °C). If running a heat-sensitive resin and heat may only be raised minimally, start by raising the temperature ...
-
ASACLEAN Purging Compound Basic Purging Tips
SunPlastech
135 views
For screw and barrel cleaning, keep the screw in the full
forward position by increasing backpressure to the MAXIMUM safe level.
Increase the screw speed to the MAXIMU...
-
Check ring - Color or carbon
SunPlastech
45 views
Feed a small amount of ASACLEAN (less than half barrel capacity). Repeat short, high-velocity injections shots until clean
-
Asaclean small steps to large savings by modifying purging procedures Part 4
SunPlastech
147 views
This is part four of a four part presentation given by Sun Plastech Inc. Vice President Joseph Serell at the 2010 Plastec West Show in Anaheim California.
-
Asaclean small steps to large savings by modifying purging procedures Part 3
SunPlastech
9 views
This is part three of a four part presentation given by Sun Plastech Inc. Vice President Joseph Serell at the 2010 Plastec West Show in Anaheim California.
Advertisement
Play all(16)