Skij710's channel
Loading...
-
4 months ago
HVAC Pump Down 2
I pump down a split system heat pump and release the refrigerant back into the line set when I'm finished.
Attention: Do not try any of what you s...
Skij710
commented:
-
9 months ago
How to Install a Paver Patio
Lowe's home improvement expert, Mike Kraft, demonstrates how to finish your patio by installing paving stones. Make sure you know the pattern you ...
Skij710
favorited
-
9 months ago
Pacific Pavingstone How to Install Paving Stones
Pacific Pavingstone goes through the step of properly installing Paving Stones. http://www.pacificoutdoorli...
Skij710
favorited
-
10 months ago
Lay It Down - RATT (cover)
ギターソロのスロー演奏だけだとつまんないと思いましたので一曲
通して弾いてみました。 参考になれば良いのですが
from the album"INVASION OF YOUR PRIVACY" + Lesson
Skij710
favorited
-
1 year ago
Totally Radical Rockford
Stepper Motor CNC Retrofit to small, old Rockford horizontal knee mill. This is more of a test project, than an actual finished CNC mill as it has...
Skij710
uploaded
-
1 year ago
Englander Furnace Secondary #2
This is retrofit number 2 with the "ladder" type system. Primary air is closed all the way, spin draft is open 1/2 turn. Little smoke from the chim...
Skij710
commented:
No The 28-3500 does not have secondary burn. This looks like it's working pretty good. I sent you a message, need more details on this if you don't mind :)
-
1 year ago
HELP!!! Gecko drive G320X
I used MACH3 to send out the signal to breakout board and GECKO drive. However, the system does not work smoothly. I have checked all connections b...
Skij710
commented:
Encoder could be the problem... Or it's being driven too fast. Try adjusting the maximum velocity to a lower setting.
-
1 year ago
Deep Foundation - Children of the Sun Remix f/ Hydroponikz Nomi Koba Kiwi & Encite. (Filipino Pride)
*CLICK HD FOR BEST VIEWING QUALITY!!!*
*FOR LYRICS, CLICK THE CC BUTTON IN THE LOWER RIGHT HAND CORNER*
This is the music video for our song, "C...
Skij710
commented:
Wu-Tang Clan - Triumph
-
1 year ago
How To Remove The Auger Assembly from a Murray Snowblower
Visit my channel for more repair videos; http://www.youtube.com/user...
-
1 year ago
HOW TO REPLACE CARBURETOR DIAPHRAGM ON TORO 2 CYCLE SNOWTHROWER PART 1
HOW TO REPLACE CARBURETOR DIAPHRAGM ON TORO S-200 2 CYCLE SNOWTHROWER PART 1, "Disassembly". Visit my channel for more repair videos. http://www.y...
Skij710
commented:
@BandOnTheRun87
It's probably the carb bowl not filling up fast enough because of a partial clog in the carb where the fuel goes into it from the tank/pump.. Remove the carb and clean out all the openings, make sure to blow air thru the passages. If the engine is old, I recommend replacing t...
-
3 years ago
CoD_WaW_Zombies0003.wmv
My solo run in Nacht Der Untoten, PC Version. This is the best I could do solo so far, as it gets extremely tough to survive :). I have found that ...
Skij710
uploaded
About Skij710's channel
In your first vid in this series, it looks like you are just putting nitrogen into the system, turning the nitrogen tank off, then removing the hose from the nitro tank and letting it just come out, then closing it off at manifold, and then reopening the service valves in reverse order from pump ...