RotorFever's channel

Testing the electronics in my new scratch built rc airplane

Using a needle to install an actuator into a small airplane.

Micro spinner made from balsa for a 6" Spitfire. The propellor is a trimmed PiccoZ helicopter tail rotor. Propellor and spinner is nicely centere...

A tiny cp heli...

http://www.walkera.com/en1/...

Specs

1).Main Rotor Diameter: 240 mm

2).Tail Rotor Diameter: 48mm

3).Over...

A modified Micro Terrain Titan being tested on the bench. A 2.4ghz receiver is installed along with a micro servo board to drive the coreless main...

Baylands Sunnyvale

Motor: 3.1g http://rotorfever.com/index...

ESC: 1s 5amp http://rotorfever.com/index......

Parkzone Sukhoi with brushless conversion.

A modded toy Levan rc car to include 2.4ghz receiver and a micro servo. Now there is full proportional steering along with full proportional throt...

Walkera 4G3 submicro rc heli.

http://www.rotorfever.com

Specification

1). Main Rotor Dia. : 302mm

2). Tail Rotor Dia. : 58mm

3). Overall Length: ...

2.4ghz Aero Ace modified with Walkera 2.4ghz transmitter and 4in1 from a 5G6.