My Lister collection
Loading...
91
subscribers
141,981
video views
Uploaded videos
1-10 of 33-
Oil tank for the vertical Babington.
Redkrabby
27 views
I almost finished the oil storage tank for my new vertical Babington burner. I still have to fit the sight glass so I can see how much oil is left in the tank. It's a sligh...
-
New design vertical Babington Burner (closed loop system)
Redkrabby
70 views
I made a new vertical Babington design. I call it a closed loop system. The burner itself is almost finished. I still have to fabricate the manual control system to adjus...
-
Drip feed waste motor oil workshop heater.
Redkrabby
95 views
Because I needed my vertical Babington burner for a other project and It's -5 degree Celsius out side I needed a new burner for my workshop heater quick. I also wanted to w...
-
Suffolk pony motor: Mounted to the engine, and testing it. (final part) .wmv
Redkrabby
266 views
I decided that the pony motor should be mounted to the engine. I had the room for it, and its safer to use it that way. I welded a new subframe and welded that in turn to t...
-
Suffolk pony motor part 4: Starting the Lister CS
Redkrabby
301 views
Today I tested the pony motor on the Lister CS generator. I worked very well. If I ever build a other one then I wil use a engine that is a bit stronger so I can use a tire...
-
Suffolk pony motor part 3: Solution for drive shaft support.
Redkrabby
120 views
I had a bearing lying around, but it did not fit the shaft, so I made a bushing on my lathe to fit the shaft where the clutch is welded on. Then I fabricated a metal ring t...
-
Suffolk pony motor part 2: Welding the support frame and testing the engine with reduction gear.
Redkrabby
135 views
Today I welded the support frame for the engine and reduction gear. I also tested the contraption. It worked fine until I noticed that there was leaking some oil from the r...
-
Suffolk pony motor part 1: Starting a Lister diesel engine with a pony motor .
Redkrabby
344 views
I was getting tired of hand cranking my Lister diesel engines. In summer its not a problem but when its cold they can be a b*tch to start. I'm running out of breath after 4...
-
Homemade gantry crane and chain hoist.mp4
Redkrabby
2,076 views
I needed something different than a engine crane to lift my engines on and of the trailer or the trolleys they are mounted on. The legs from the engine crane are always in ...
-
My homemade (tilting) milling vice.
Redkrabby
936 views
I made a milling vice for my milling machine. I do have a professional vice, but that one is a bit bulky and cant tilt. For a project I'm working on at the moment I needed ...
Play all(33)