IvanBarb4's channel
Loading...
60
subscribers
49,201
video views
Uploaded videos
1-10 of 59-
Realfligh G5 Training Update #3
IvanBarb4
16 views
Not too much different to the previous update, a little more fluent then before with more inverted circuits...piro flips are still far too messy. All but the funnels have b...
-
HK 450 v2 Back in action
IvanBarb4
101 views
The $9 HK 450 v2 is back in action after lengthy tail issues and shit weather.
Replaced a bunch of electronics only to discover it was the tail assy...The tail assy had soo...
-
HK450v2 - Gear fail
IvanBarb4
92 views
Heli crashed due to the Tail drive gear slipping off the gear shaft loosing all tail power resulting in a death spin ( I think I had the belt a little too tight )...fortuna...
-
HK450v2 (G401B + 9257 clone...servo dies)
IvanBarb4
105 views
I settled on the xmhobbies G401B + the 9257 clone servo...During a test hover, the tail wasn't locked in anywhere near the last time I had this setup.
During the test flig...
-
HK450v2 (Gy48v + PowerHD 9257 clone) Part-4
IvanBarb4
88 views
This is the last of my tail combos... the gy48v didn't live up to my expectations...I was certain that this would be the gyro to stay on the heli...from the videos watched ...
-
Realflight G5 3D training update.
IvanBarb4
50 views
This is where I'm at on the sim...hoping to be doing it in the field soon.
-
HK450v2 (Turnigy 302 + PowerHD 9257 clone) Part-3
IvanBarb4
110 views
Tested the Turnigy 302 Gyro (telebee clone)...Not very happy with it, particularly cos its the most expensive of all I've been testing $25 (nice packaging). It behaves like...
-
Futaba s9257 tail servo versus its clones
IvanBarb4
491 views
I myself was curious about the comparison between the real s9257 and its clones.
I tested speed, resolution and centering and was very surprised with the results.
Reliabi...
-
Gyro & Tail setup (401 type)
IvanBarb4
631 views
Pause video for more detail. This video shows the Futaba GY-401 gyro way of setting up the tail & gyro using a G401B + clone 9257 combo.
Dx6i transmitter used.
-
HK450v2 (G401b + 9257 clone) Part-2
IvanBarb4
190 views
17th session...This is a newly built $9 ($23) HK450v2...this time around I decided to install the $10 D933MG cyclic servos replacing the HXT900. The digital servos improve ...
Advertisement
About IvanBarb4's channel
more
less
Play all(59)